valutazioni - 3, GPA: 4.3
(
)
)
|
Foto e specifiche Yamaha NS-P125 |
Facilità d'uso
• Do not fasten the speakers to wall with nails, adhesives, or other unsound hardware. Long term use and vibrations may cause them to fall down. • To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall. Note: You can also use the screw holes on the bottom of the NS-M125 for installing the speakers on commercially available speaker stands. A screw with a diameter of 6 mm (1/4”) can be used (Hole depth: 20 mm, 3/4”) 60 mm (2- 3/8” ) • Before installing, please refer to the instruction manual of the speaker stand. English E-3 ¦ ¦ Place the speaker on the floor under the TV or inside the TV rack so that it is stabilized. ¦ Mounting the center speaker NS-C125 on the wall The speaker can be mounted on a wall by using the bracket attached to the speaker’s back panel. When placing the speaker on top of the TV To prevent the speaker from falling down, put the provided fasteners at two points on both bottom of the speaker and top of the TV. Holes 12Peel off the seal TV set Fastener NS-C125 NS-C125 Notes: • Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. Wall or wall support Tapping screw (commercially available) Diam. 3.5 to 4 mm (1/8”) 3 mm (1/8”) Min. 20 mm (3/4”) Make sure that the screws are caught by a narrow part of the holes securely. 292 mm (11-1/2”) Fasten screws into a firm wall or wall support as shown in the figure below, and hang the holes on the protruding screws. If placed, the speaker may drop out causing an injury to you. • Do not place the speaker on top of the TV with an inclination. • Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength. • Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop. WARNING: • The speaker weights 2 kg (4.4 lbs). Do not mount them on thin plywood or soft wall surface material, as the screws may come out of the flimsy surface, causing the speakers to fall down and be damaged, or result in personal injury. • Do not fasten the speakers to wall with nails, adhesives, or other unsound hardware. Long term use and vibrations may cause them to fall down. • To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall. Connecting Your Speakers Always turn off your amplifier or receiver before making any connections. ¦ Preparing Your Speaker Cables Carefully remove 10 mm (3/8 ”)of insulation from both ends of your 10 mm (3/8 ”) speaker cables and twist the bare wires tightly, as shown. Good No Good ¦ Hookup NS-C125 CENTER FRONT OR SURROUND R L + – NS-M125 Amplifier or receiver + – Loosen Tighten Notes: • Make sure that the bare wires are not touching each other as this could damage the speaker and amplifier. • Connect one speaker to the left terminals of your amplifier, and another speaker to the right terminals, making sure not to reverse the polarity (+, –). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass. ¦ Using a Banana Plug 1. Remove the speaker terminal cover by gently pulling it toward you. 2. Tighten the terminal knob. 3. Simply insert the banana plug into the 1 terminal. 3 2 Banana Plug English E-5 Specifications NS-M125 Type.................2-way bass reflex speaker system magnetic shielding type Driver ...................... 8 cm (3.1”) cone woofer x 2 3 cm (1”) balanced dome tweeter Impedance...................................................... 6 . Frequency Response ..................70 Hz to 35 kHz Rated Input Power........................................40 W Maximum Input Power ..............................120 W Sensitivity .................................. 86 dB/2.83 V/m Crossover Frequency...................................6 kHz Dimensions (W x H x D) ...........105 (4.1”) x 340 (13.4”) x 133 (5.2”) mm Weight..........................................2.2 kg (4.9 lbs) NS-C125 Type.................2-way bass reflex speaker system magnetic shielding type Driver ...................... 8 cm (3.1”) cone woofer x 2 3 cm (1”) balanced dome tweeter Impedance ...................................................... 6 . Frequency Response ..................70 Hz to 35 kHz Rated Input Power........................................40 W Maximum Input Power ..............................120 W Sensitivity................................... 86 dB/2.83 V/m Crossover Frequency...................................6 kHz Dimensions (W x H x D) ............ 340 (13.4”) x105 (4.1”) x 133 (5.2”) mm Weight.............................................2 kg (4.4 lbs) * Specifications are subject to change without notice due to product improvements. i NS-P125 SYSTEME D’ENCEINTES CENTRALE ET D’EFFETS AUDIO/VIDEO NS-C125/NS-M125 SYSTEME D’ENCEINTES Nous vous remercions d’avoir opte pour le systeme d’enceintes de Yamaha. Francais • Le NS-P125 est u...