Online answers: Text Box: Before installing or starting this unit for the first time, this manual should be studied carefully to obtain a working knowledge of the unit and/or the duties to be performed while operating and maintaining the unit. RETAIN THIS MANUAL WITH UNIT. This Technical manual contains IMPORTANT SAFETY DATA and should be kept with the unit at all times. Text Box: C.C.N. : 80443864 REV. : A DATE : APRIL 2007 SECTION 1 — TABLE OF CONTENTS SECTION 1 — TABLE OF CONTENTS............

Defective safety/relief vatve. U_it does not come up to 1 Loose beltwheel or motor pulfey, excessive end play in t Check beflwheel, motor pulley, crankshaft, drive bett ter_sSen speed motor shaft or loose drive belts and alignment, Repair or replace as required, 2. Lubricant viscosity tea high 2 Drain existing lubricant and retill wilh proper lubricant 3 Improper line voltage 3. Check line voltage and upgrade lines as required Contact 4 Compressor valves leaky, broken, carbonized or loose electr

RETAIN FOR REFERENCE. SAFETY DEFINITIONS A DANGER WILL cause DEATH, SEVERE INJURY or substantial property damage. A WARNING CAN cause DEATH, SEVERE INJURY or substantial property damage. A CAUTION WILL or CAN cause MINOR INJURY or property damage. GENERAL SAFETY PRECAUTIONS _ A DANGER A WARNING A CAUTION INTAKE AIR. Can contain carbon monoxide or other contaminants. Will cause serious injury or death. Ingersoll-Rand air compressors are not designed, intended or approved for breathin

The vent knob should be closed prior to pressurizing the system by turning the knob away from the pump housing. The Vernier knob can be used to increase or decrease the system at a more controlled rate. For fast relieve of the pressure, move the pressure/vacuum pin to the opposite direction. Pressure/Vacuum Selector The pump can be used to generate pressure or vacuum depending on the position of the pin located in the pressure/vacuum switch. Press the pin on the side of the pump housing accordin

Single-Phase Wiring T = Supply Line Terminal L = Load Terminal uJ L=J L1 Pressure switch used disconnecLorclrcu_t breaker (inctltde_ on/auto-off switch) Singie phase m_or COMPRESSOR LUBRICATION CAUTION Do not operate without lubricant or with inadequate lubricant. Ingersoll-Rand fs not responsible for compressor failure caused by inadequate lubrication SYNTHETIC LUBRICANT. We recommend thgersolI-Rand synthetic compressor lubricant from start-up See the WARRANTY section for extended warranty info

Will cause serious injury or death ingersoll-Rand air compressors are not designed, intended or approved for breathing air Compressed air should not be used for breathing air applications unless treated in accordance with all applicable codes and regulaUons,, WARNING HAZARDOUS VOLTAGE Can cause serious injury or death. Disconnect power and bteed pressure from tank before servicing Lockout/Tagout machine. Compressor must be connected to properly grounded circuit See grounding instructions in manu

ARE HEREBY DISCLAIMED Correction by the Company of nonconformities, whether patent or latent, in the manner and for the period of time provided above, shall constitute fulfillment of all liabilities of the Company and its Distributors for such nonconformities with respect to or arising out of such Equipment LIMITATION OF LIABILITY THE REMEDIES OF THE PURCHASER SET FORTH HEREIN ARE EXCLUSIVE, AND THE TOTAL LIABILITY OF THE COMPANY, ITS DISTRIBUTORS AND SUPPUERS WITH RESPECT TO CONTRACT OR THE EQU