valutazioni - 0, GPA: 0
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
Back to Contents Page Hard Drive Dell™ Latitude™ D531 Service Manual Removing the Hard Drive Replacing the Hard Drive Returning a Hard Drive to Dell Removing the Hard Drive 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the two M3 x 3-mm hard drive screws. 3. Slide the hard drive out of the computer. Replacing the Hard Drive 1. Remove the new drive from its packaging, if applicable. Save the original packaging for storing or shipping the hard drive. CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide. CAUTION: Do not touch the metal housing of the hard drive if you remove the hard drive from the computer while the drive is hot. NOTICE: To prevent data loss, turn off your computer before removing the hard drive. Do not remove the hard drive while the computer is on or in a power management mode. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as the back panel on the computer. NOTICE: To avoid damaging the hard drive, handle the drive with care. NOTE: Dell does not guarantee compatibility or provide support for hard drives obtained from sources other than Dell. NOTE: If you are installing a hard drive obtained from a source other than Dell, you may need to install an operating system, drivers, and utilities on the new drive. 1 M3 x 3-mm screws (2) 2 hard drive NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge" in the Product Information Guide). CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as the back panel on the computer. NOTICE: Use firm and even pressure to slide the drive into place. Excessive force may result in damage to the connector. 2. Slide the hard drive into the bay until it is fully seated. 3. Replace the two M3 x 3-mm screws to secure the hard drive. 4. Install the operating system for your computer, if necessary (see "Restoring Your Operating System" in your User's Guide). 5. Install the drivers and utilities for your computer, if necessary (see "Reinstalling Drivers and Utilities" in your User's Guide). Returning a Hard Drive to Dell Return your hard drive to Dell in the replacement drive's foam packaging. Otherwise, the hard drive may be damaged in transit. Back to Contents Page NOTE: The hard drive should be inserted in the replacement drive's antistatic bag before being placed in the foam packaging. 1 foam packaging 2 hard drive Back to Contents Page Hinge Cover Dell™ Latitude™ D531 Service Manual Removing the Hinge Cover Replacing the Hinge Cover Removing the Hinge Cover 1. Follow the procedures in Before Working Inside Your Computer. 2. Turn the computer over and open the display all the way (180 degrees) so that it rests flat on your work surface. 3. Insert a plastic scribe into the indent along the right edge of the hinge cover, and then carefully pry the hinge cover loose. 4. Moving from right to left, ease the hinge cover up and remove it from the computer. Replacing the Hinge Cover 1. Align the two tabs along the left edge of the hinge cover with the corresponding notches in the computer. 2. Moving from left to right, press down until the hinge cover snaps into place. Back to Contents Page CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as the back panel on the computer. NOTICE: The hinge cover is fragile and can be damaged if extreme force is used. Exercise care when removing the hinge cover. NOTICE: To avoid damaging the hinge cover, do not lift the cover on both sides simultaneously. 1 hinge cover 2 indent CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as the back panel on the computer. NOTICE: The hinge cover is fragile and can be damaged if extreme force is used. Exercise care when replacing the hinge cover. Back to Contents Page Keyboard Dell™ Latitude™ D531 Service Manual Removing the Keyboard Replacing the Keyboard Removing the Keyboard 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the hinge cover (see Removing the Hinge Cover). 3. Remove the three M2 x 3-mm screws at the top of the keyboard. 4. Lift the keyboard only enough to hold it up and sligh...