(98 cm) Weight (without batteries) 544 lb. (246 kg) Weight (dry, without battery) 669 lb. (303 kg) Forward speed 17 mph (27 km) Vehicle Specifications continued on next page... Page 46 2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Vehicle Specifications SPECIFICATIONS Electric HUV4210-E Electric HUV4210EXP Gasoline HUV4210-G Gasoline HUV4210GXP Standard seating capacity 2 LIQUID CAPACITIES Transaxle 22 oz. (0.67 L) Engine crankcase (without filter) 32 oz. (0.95 L) Engine c

See Battery – Gasoline Vehicles on page 39. Front wheel alignment and camber Check and adjust if necessary. See Section 7 – Steering and Front Suspension in the appropriate maintenance and service manual. Electrical wiring and connections Check for tightness and damage. Brake system Check brake shoes; replace if necessary. Lubricate brake slides. See Periodic Lubrication Schedules on page 32. Check brake cables for damage; replace if necessary. Annual service by trained technician only (or every

• Study and understand controls. TO START ENGINE • Place shift lever in “N” Neutral position. • Press brake pedal. • Turn key switch to “START position and release. TO OPERATE VEHICLE • Turn wheels to desired direction and ensure path is clear. • Engine must be at idle before moving shift lever. • While vehicle is stopped, and engine is at idle, place Forward/Reverse switch in desired position: F Forward N Neutral R Reverse (Buzzer will sound) • Park brake will release and vehicle will start mov

Completely open the fuel shut-off valve (Figure 17). Make sure the valve is fully open. A partially closed fuel shut-off valve (Figure 18) combined with the use of the choke can result in a fouled spark plug and engine failure. 4. Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into the carburetor and fuel lines and the engine starts. Turn the engine off. See following NOTE. NOTE: Due to the oil added to the engine in preparation for storage, engin

NOTE: If the vehicle is constantly subjected to heavy use or severe operating conditions, the preventive maintenance procedures should be performed more often than recommended in the Periodic Service and Lubrication Schedule. Both the Periodic Service Schedule and the Periodic Lubrication Schedule must be followed to keep vehicle in optimum operating condition. PERIODIC SERVICE SCHEDULE REGULAR INTERVAL SERVICE Daily service by owneror trained technician Engine Check engine oil level; add if nec

• Unload cargo bed before raising vehicle with a lift, hoist, or jack. • Avoid stopping on a hill when loaded. If you must stop on a hill, avoid sudden starts, or rollingbackwards and stopping suddenly. Failure to heed this warning may cause vehicle to overturn, possibly resulting in severe personal injury. WARNING CONTINUED ON NEXT PAGE... Page 22 2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual Vehicle Load Capacities y WARNING • Reduce speed and avoid sudden stops when backing up. Fai

If the battery is dead, see Using A Booster Battery (Jump Starting) on page 52. 3. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Chock the wheels. 4. Gasoline vehicles: Prepare the fuel tank. 4.1. Fill the tank with fresh fuel. 4.2. Following the manufacturer’s directions, add a commercially available fuel stabilizer (such as Sta-Bil®). Run the engine in a well-ventilated area to allow treated fuel to replace untreated fuel in the carb

LUBRICATION CHANGE FOR FRONT DIFFERENTIAL, TRANSMISSION, AND REAR DIFFERENTIAL Use the lower plug (2) for drainage (Figure 30, Figure 31, or Figure 32). Remove both plugs to allow the lubricant to drain faster. See preceding NOTE. Metal particles may be discovered in the fluid or on the magnetic drain plug when changing the differential or transmission fluid. These particles are normal and expected for the first few fluid changes. This is a result of the gears being “net forged”, meaning the gea

Never install tires of differentdiameters on the vehicle. • Reduced steering control can occur when the front differential is locked. STOPPING THE VEHICLE To stop the vehicle, release the accelerator pedal and press the brake pedal until the vehicle comes to a complete stop. See following WARNING and CAUTION. WARNING • Driving through water may affect the brakes. After driving through water, check effectiveness of thebrakes by gently pressing the brake pedal. If the vehicle does not slow down at

• The vehicle is not specially equipped for handicapped persons: – Be sure all passengers are capable of securing themselves in a moving vehicle before allowingthem to ride in one. – Be sure all persons can properly operate the vehicle prior to allowing them to drive the vehicle. • Stop the vehicle before shifting the Forward/Reverse handle. Engine must be at idle before shiftingthe Forward/Reverse handle. Failure to do so may result in injury to inattentive passengers and(or) damage to the vehi