valutazioni - 4, GPA: 4
(
)
)
|
Facilità d'uso
Safety precautions -Please note that the dehumidifier's voltage is equivalent to the mains voltage. -Do not plug in to the mains where other electrical appliances are already plugged in. -Use the dehumidifier only for the purpose(s) defined in the user guide. -Never insert your fingers, pencils or other objects into the air intake during operation. -Switch off before moving or cleaning the device. -Do not expose to strong heat, as this can cause damage to the electrical components. -Do not immerse in any form of liquid. -Always keep out of the reach of children. -Do not run the cable under carpets, rugs, etc. -Ensure the cable is kept away from busy areas to avoid anyone tripping over it. -For indoor use only. -Do not cover. Danger of overheating! -Do not use if the device or cable become damaged. Take it to a specialist for repair. -If the device has been transported in a horizontal position, oil from the compressor can have leaked into the system. It is therefore important to let it stand upright for a few hours before use. This will allow the oil to run back into the compressor and avoid damage. The volume of moisture the device can extract from the air depends on temperature, level of humidity and placing. The weather outside can also have an effect on how much moisture can be extracted from the air. In cold weather, the relative humidity falls causing a corresponding fall in the amount of moisture that can be extracted. Key: 1. Operating panel 2. Air intake 3. Water tank (4 litres) 4. Wheels 5. Air exhaust 6. Permanent drain hole 7. Cable winder 8. Cable 1. 2. 3. 4. 5. 6. 7. 8. Operating panel: 1. Start/stop button 1. Key to display. Tank full indicator: lights when the tank is full. A lamp will light when the device is switched on. Before use Find a suitable place close to a mains electricity socket. The dehumidifier is fitted with for easy manoeuvrability. Caution is advised in placing the device for operation. It should not be placed near heating appliances or other heat sources, or in direct sunlight as this will cause reduced performance. Improved performance can be achieved by ensuring the room is maintained at a temperature over +5C°. Plug in to a mains plug socket (220-240V ~50Hz) Ensure that the water tank is positioned correctly, or the dehumidifier will not start. If the dehumidifier is to be used near swimming pools or bathrooms, it must be securely mounted and be connected to earth. Installation: It is important that the device is positioned on a firm level surface well away from other objects. There must be a minimum distance of 30 cm from walls or other objects. Do not cover the air exhaust vent. -To start, press the “I/O” button (on/off) -Full water tank -The tank-full indicator will light when the tank is full. The device will switch off automatically. -Do not empty the tank while the device is running. It must be at a complete standstill before the tank can be removed. -When the tank is replaced in the device, it is ready to operate again. Permanent drain. A hose with an internal diameter of 11.5 mm is required for a permanent drain.( not incl.) -Remove the blank on the back of the device with a screwdriver or similar implement. Pass the hose through to the drain nozzle and secure. -Ensure there are no kinks in the hose and that it is not trapped. Maintenance: Always remover the plug from the socket before cleaning. 10 FILTER If the filter is covered with dust, airflow and dehumidifying efficiency will be reduced. Cleaning the filter every 14 days is recommended. To clean the filter: -Disconnect the electricity. Remove the grille in front of the air intake (see fig. A). Remove the filter as shown in fig. B. -Vacuum-clean the filter, or wash in warm water. Dry before use -Replace the filter as shown in fig. C. Clean the water tank in warm water with a neutral detergent. Replace the tank in the device after cleaning. Do not use cleaning materials containing solvents when cleaning the cabinet. Use a well-wrung damp cloth. Dry off with a dry cloth. Trouble Shooting ENVIRONMENTAL TIPS Once any electrical or electronic product is no longer functional, it should be disposed of in such a way as to cause minimum environmental damage. The device should be disposed of in accordance with the applicable regulations of your local authority. In most cases you can take such products to your local recycling station. The compressor contains: 180g R134A gas THE GUARANTEE DOES NOT APPLY If the instructions given above are not observed. If the device has been mishandled, subjected to rough treatment or has suffered any other form of damage. If the device has been subject to unauthorised repairs. For faults that may have arisen as a result of faults in your electricity supply. For faults that arise as a result of incorrect or unauthorised installation Due to the constant development of our products in terms of function and design, we reserve the right to make changes to the product without prior warning. I...