valutazioni - , GPA:
(
)
)
Produttore : Coleman
File Size : 656.49 kb
File Nome : 60b73b5c-1221-45ac-9ee0-1289491d5ba5.pdf
Lingua di insegnamento: 
Il documento viene caricato, si prega di attendere
 |
Il documento viene caricato, si prega di attendere
Facilità d'uso
OFFFIG. 8 FIG. 9 FIG. 10 FIG. 11 BLACK PUMP ASSEMBLY BOTTLE FUEL VALVE “O” RING English-6 5 5 To Attach Fuel Bottle ¦ Make sure FUEL VALVE is fully “OFF” (Fig 12). ¦ Connect hose to threaded fitting on fuel bottle, making sure the bottle is lying on its side with the fuel valve up. Hand tighten the connection (Fig. 13). FIG. 12 FIG. 13 Note: For proper lighting, perform Step 6 ONLY for the first time use “out of the box” or when pump is dry (for example, after extended storage). This step is not required during subsequent lighting. 6 6 Initial Fueling of Dry Pump ¦ Make sure FUEL VALVE is fully “OFF” (Fig 14). ¦ Turn flame adjuster to “High/Light” (Fig. 15). ¦ Place thumb over hole in PUMP KNOB and pump five full strokes (Fig 16). ¦ Open fuel valve on bottle 1/2 turn for five seconds, then close fuel valve. NOTE: Air in the dry pump is now replaced with liquid fuel. Proceed to Step 7. FUEL VALVE FIG. 14 FIG. 15 FIG. 16 English-7 7 7 To Pump ¦ Make sure FUEL VALVE is fully “OFF” (Fig 17). ¦ Place thumb over hole in PUMP KNOB and pump 25 full strokes (Fig 18). Adequate air pressure is important, do not over pump. FUEL VALVE FIG. 17 FIG. 18 8 8 Leak Check WARNING WARNING • Perform leak test outdoors. • Extinguish all open flames. • NEVER leak test when smoking. • BURN HAZARD • Do not use the outdoor stove • Never leave stove unattended until connection has been leak when hot or in use. tested and does not leak. • Keep out of reach of children. ¦ Make sure FUEL VALVE is fully “OFF” (Fig. 19). ¦ CHECK FOR LEAKS in one or more ways: Look for a fuel mist or a wet appearance of fuel on surfaces. Listen for hiss of escaping gas. Smell for fuel odor. Never use a flame. Do not use if leaking. CHECK FOR LEAKS Liquid Fuel Canister FIG. 19 English-8 9 9 To Light NEVER FILL OR LIGHT STOVE INSIDE HOUSE, CAMPER, OR TENT. ¦ Make sure fuel bottle is lying level on its side with the FUEL VALVE up (Fig. 20). ¦ Turn flame adjuster back and forth several times to clean generator tip (Fig. 21). ¦ Turn flame adjuster to “High/Light” (Fig. 22). ¦ Hold lighted match at burner and then open fuel valve (Fig. 20 and 23). ¦ CAUTION: If stove burns with a high yellow flame or if liquid fuel appears in the burner, immediately turn FUEL VALVE “OFF.” Allow stove to cool. Carefully review the troubleshooting section before relighting stove. ¦ After stove warms up (approx. 1 minute), pump an additional 40 strokes. Flame may be adjusted to desired heat with FLAME ADJUSTER. Periodically turn flame adjuster back and forth several times to clean generator tip (Fig. 21). ¦ Pump as required to maintain flame height. WARNING: Keep fuel bottle at least 8” from lit stove. FIG. 20 FIG. 21 To Turn Off 10 FIG. 22 FIG. 23 ¦ Turn FUEL VALVE fully “OFF” (Fig. 24). ¦ Be sure flame is extinguished. Flame will linger on burner for 1-2 minutes after fuel valve is “OFF”. WARNING • Always turn fuel valve off before removing hose. Never remove hose from bottle near ignition sources, while stove is lit, or hot to touch. FUEL VALVEFIG. 24 English-9 DANGER • EXPLOSION - FIRE HAZARD • Always attach or detach fuel canisters outdoors; never while stove is lighted, near flame, pilot lights, other ignition sources or while stove is hot to touch. • This stove is very hot during use and can ignite flammables too close to the burners. Keep flammables at least 24 inches from the sides and 48 inches from the top of the stove. Keep gasoline and other flammable liquids and vapors well away from stove. • The stove must not be exposed to flammable vapors or liquids during lighting. 11 11 Using the Reflector Disc and Windscreen CAUTION Always place the stove on the reflector disc during setup and use. The disc must be used to help protect combustible surfaces from excess heat and cooking splatter. ¦ Always place the stove on the reflector disc during setup and use. ¦ To improve stove performance in windy conditions, unfold the windscreen and place it around the stove. Fold the ends together. Place the windscreen so that the notched end is down and allows access to the flame adjuster (Fig. 25). ¦ Roll or gently fold the windscreen for storage. FIG. 25 English-10 12 12 To Store ¦ Make sure stove is cool. ¦ Move stove away from flame (including pilot lights) and other ignition sources. ¦ Disconnect the fuel hose at the threaded fitting attached to the fuel bottle. ¦ If some liquid fuel remains in the fuel hose, drain the excess fuel before placing the stove in your backpack or storage container. ¦ Replace the protective caps onto the threaded fittings. ¦ The stove may be folded for compact storage (Fig. 26). The hose remains attached to the stove. FIG. 26 • MAINTENANCE • Keep stove area clear and free from combustible materials, gasoline and other flammable vapors and liquids. • Do not obstruct the flow of combustion and ventilation air. • A good flame should be blue with minimal yellow tip. Some yellow tips on flames are acceptable as long as no carbon or soot deposits appear. • Wipe ...