valutazioni - 0, GPA: 0
(
)
)
|
Facilità d'uso
– Then add salt (not table salt). The water is displaced and runs out. * depending on model The salt refill indicator H on the fascia is lit. It goes out as soon as a sufficiently high salt solution has formed. If the set hardness value is “0”, do not add salt because no salt is used during operation; the salt refill indicator is switched off. If the set values 1 to 3 are displayed, salt must be added. Using detergents with salt component If combined detergents with a salt component are used, salt can usually be omitted up to a water hardness of 21° dH (37° fH, 26° Clarke, 3.7 mmol/l). If the water hardness is over 21° dH, special salt must be used. Salt refill indicator As soon as the salt refill indicator H on the fascia is lit, top up the salt. Depending on the washing frequency and the hardness setting, the regeneration salt may not have to be topped up for several months. a=Warnings – Never fill the salt dispenser with detergent. You will destroy the water softening system. – To prevent corrosion, always refill with salt immediately before switching on the appliance. en Rinse aid % As soon as the rinse-aid refill indicator P is lit on the fascia, there is still a rinse-aid reserve of 1–2 rinsing processes. Refill with rinse aid. The rinse aid is required for stain-free utensils and clear glasses. Use only rinse aid for domestic dishwashers. Combined detergents with rinse-aid component may be used up to a water hardness of 21° dH (37° fH, 26° Clarke, 3.7 mmol/l) only. If the water hardness is over 21° dH, rinse aid must be used. – Open the cover on the rinse-aid dispenser 1j. To do this, press the mark (1) on the cover and simultaneously lift the cover on the control plate (2). – Carefully pour in the rinse aid to just below the edge of the filler opening. –Close cover until it clicks shut. –To prevent excessive foam formation during the next rinse cycle, remove any rinse aid which has run over with a cloth. Setting amount of rinse aid The rinse aid dispensing rate can be adjusted steplessly. The clear rinse controller was set to 4 at the factory. Do not change the position of the rinse aid control unless there are streaks (rotate towards –) or water stains (rotate towards +) on the utensils. . . Switching the rinse aid refill indicator off or on If the rinse-aid refill indicator P is impaired (e.g. when using combined detergents containing rinse aid component), it can be switched off. To change the setting: – Hold down the timer programming button 8 and press main switch ( until the display is lit. – Release buttons. – By pressing the timer programming button 8, you can switch the rinse- aid indicator off or on. – Switch off the main switch (; the chosen setting has now been stored. en 9 Not suitable – Cutlery and utensils made of wood. – Delicate decorative glasses, craft and antique utensils. These decors are not dishwasher-proof. – Plastic parts not resistant to heat. – Copper and tin utensils. – Utensils which are soiled with ash, wax, lubricating grease or ink. Aluminium and silver parts have a tendency to discolour and fade during the wash cycle. Even some types of glass (e.g. crystal glass objects) may turn cloudy after many wash cycles. Glass and utensil damage Causes: – Glass type and glass production process. – Chemical composition of the detergent. – Water temperature of the wash programme. Recommendation: – Use only glasses and porcelain which the manufacturer designates as dishwasher-proof. – Use a detergent which protects utensils. – Take glass and cutlery out of the dishwasher as soon as possible after the programme ends. Loading the dishwasher – Remove large food remnants. It is not necessary to prerinse utensils under running water. – Place the utensils so that – they are secure and cannot tip over. – all utensils with their openings face down. – parts with curves or indentations are at an angle, thereby allowing water to drain. – does not obstruct rotation of the two spray arms 12 and 1:. Very small utensils should not be washed in the machine, as they may fall out of the baskets. Unloading the dishwasher To prevent water from dripping off the upper basket onto the utensils in the lower basket, it is recommended to empty the appliance from the bottom up. Hot utensils are sensitive to shock! Therefore, when the programme ends, leave the utensils to cool down in the dishwasher until they can be handled. Cups and glasses Top basket 1" Pans Bottom basket 1Z Utensils en Tip Heavily soiled utensils (pans) should be placed in the bottom basket. The more powerful spray jet provides a better dishwashing result. Cutlery basket You should always place cutlery unsorted with the points downwards. To prevent injuries, place long, pointed implements and knives on the knife shelf. Knife shelf * * depending on model Long knives and other utensils can be arranged horizontally. You can remove the knife shelf to wash taller utensils. Folding spikes * * depending on model The spikes can be folded dow...
Questo manuale è adatto anche per i modelli :Lavastoviglie - SRV43M33EU/36 (1.51 mb)
Lavastoviglie - SRV43M33EU/38 (1.51 mb)
Lavastoviglie - SRV43M33EU/40 (1.51 mb)
Lavastoviglie - SRV43M33EU/41 (1.51 mb)