valutazioni - 3, GPA: 4
(
)
)
|
Facilità d'uso
If the Bath Seat is not properly assembled and adjusted, personal injury and damage to the Bath Seat could result. WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT use substitute parts. Use only Lumex replacement parts. Non-Lumex replacement parts could cause personal injury and damage to the Bath Seat. WARNING: This product has a weight limit of 350 lb. WARNING: DO NOT use this product as a transfer bench or climbing device. WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury caused by improper assembly or use of this product. ASSEMBLY 1. Remove the Bath Seat from the box and place it on a flat, dry surface. figure 1figure 2figure 3figure 4 2. Locate the seat legs (see figure 1). 3. Locate the shortest screw knob and a curved washer (see figure 2). 4. Lay legs in “X” pattern over seat bottom (see figures 3 and 4). WARNING: Legs must be positioned exactly as shown in figure 3 for a safe and proper fit. 5. Install curved washer on screw knob. Fasten legs to seat by inserting screw knob through center leg holes into seat and turning screw knob clockwise. Ensure screw knob is tight without overtightening. WARNING: Ensure legs are securely installed and all hardware is tight before proceeding. Note: If you are assembling 7921R (with backrest), proceed to step 6. If you are assembling 7931R (without backrest), proceed to step 8b. 6. Locate backrest tubes, backrest, four screw knobs, and four curved washers (see figure 5). 7. See figure 6. Install curved washers on screw knobs. Install backrest tubes on backrest. Attach backrest tubes to backrest by inserting screw knobs through backrest holes into backrest and turning the screw knobs clockwise. Ensure screw knobs are tight without overtightening. Caution: Do not overtighten screw knobs. figure 5 (7921R)figure 6 (7921R) GF Health Products, Inc. is not responsible for typographical errors. Packaging, warranties, products and specifications are subject to change without notice. Graham-Field and Lumex are registered trademarks of GF Health Products, Inc. Made in China. © 2010 GF Health Products, Inc., 2935 Northeast Parkway, Atlanta, GA 30360, tel 800-347-5678, fax 800-721-0601 GF0500057RevD10 2 8. Locate the four remaining screw knobs and curved washers. a. 7921R (with backrest): The screw knobs will attach the backrest and outer legs to the seat. Install curved washers on screw knobs. Lay seat upside down on flat surface as shown in figure 7. Lay backrest tubes on leg assembly, aligning holes. Insert screw knobs through backrest tube holes, through leg assembly holes, and into seat bottom. Secure by turning screw knobs clockwise; ensure screw knobs are tight without overtightening. b. 7931R (without backrest): The screw knobs will attach the outer legs to the outer seat. Lay seat upside down on flat surface. Insert screw knobs through leg assembly holes and into seat bottom. Secure by turning screw knobs clockwise...
Questo manuale è adatto anche per i modelli :Bagno - 7931R (869.26 kb)