valutazioni - 0, GPA: 0
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
MC6040-PNQW1437YA-QRG-en.book Page 20 Thursday, February 11, 2010 8:37 AM
4. General Information
4
F G
C en
C er
an a
d l Inf
Ot or
he m
r I at
nf ion
ormation
4.1 FCC and Other Information
This device complies with Part 15 of the FCC Rules.
The REN is used to determine the number of devices
Operation is subject to the following two conditions:
that may be connected to a telephone line. Excessive
(1) This device may not cause harmful interference, and
RENs on a telephone line may result in the devices not
(2) this device must accept any interference received,
ringing in response to an incoming call. In most but not
including interference that may cause undesired
all areas, the sum of RENs should not exceed five
operation.
(5.0).To be certain of the number of devices that may be
connected to a line, as determined by the total RENs,
CAUTION:
contact the local telephone company. For products
Any changes or modifications not expressly approved by
approved after July 23, 2001, the REN for this product is
the party responsible for compliance could void the
part of the product identifier that has the format
user’s authority to operate this device.
US:AAAEQ##TXXXX. The digits represented by ## are
NOTE:
the REN without a decimal point (e.g., 03 is a REN of
This equipment has been tested and found to comply
0.3).
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
If this equipment causes harm to the telephone network,
provide reasonable protection against harmful
the telephone company will notify you in advance that
interference in a residential installation. This equipment
temporary discontinuance of service may be required.
generates, uses, and can radiate radio frequency energy
But if advance notice isn't practical, the telephone
and, if not installed and used in accordance with the
company will notify the customer as soon as possible.
instructions, may cause harmful interference to radio
Also, you will be advised of your right to file a complaint
communications. However, there is no guarantee that
with the FCC if you believe it is necessary.
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
The telephone company may make changes in its
or television reception, which can be determined by
facilities, equipment, operations or procedures that could
turning the equipment off and on, the user is encouraged
affect the operation of the equipment. If this happens the
to try to correct the interference by one or more of
telephone company will provide advance notice in order
the following measures:
for you to make necessary modifications to maintain
— Reorient or relocate the receiving antenna.
uninterrupted service.
— Increase the separation between the equipment and
receiver.
If trouble is experienced with this equipment, for repair or
— Connect the equipment into an outlet on a circuit
warranty information, please contact a Factory Service
different from that to which the receiver is connected.
Center or other Authorized Servicer. If the equipment is
— Consult the dealer or an experienced radio/TV
causing harm to the telephone network, the telephone
technician for help.
company may request that you disconnect the equipment
until the problem is resolved.
Responsible Party:
Panasonic Corporation of North America
Connection to party line service is subject to state tariffs.
One Panasonic Way, Secaucus, NJ 07094
Contact the state public utility commission, public service
Technical Support:
commission or corporation commission for information.
Panasonic Corporation of North America
One Panasonic Way, Secaucus, NJ 07094
If your home has specially wired alarm equipment
Telephone: 1-800-211-PANA (7262)
connected to the telephone line, ensure the installation of
this equipment does not disable your alarm equipment. If
This equipment complies with Part 68 of the FCC rules
you have questions about what will disable alarm
and the requirements adopted by the ACTA. On the rear
equipment, consult your telephone company or a
of this equipment is a label that contains, among other
qualified installer.
information, a product identifier in the format US:ACJ-----
-----.
This equipment is hearing aid compatible as defined by
If requested, this number must be provided to the
the FCC in 47 CFR Section 68.316.
telephone company.
• Registration No .....(found on the rear of the unit)
WHEN PROGRAMMING EMERGENCY NUMBERS
• Ringer Equivalence No. (REN)
AND(OR) MAKING TEST CALLS TO EMERGENCY
...............................(found on the rear of the unit)
NUMBERS:
1) Remain on the line and briefly explain to the
A plug and jack used to connect this equipment to the
dispatcher the reason for the call.
premises wiring and telephone network must comply
2) Perform such activities in the off-peak hours, such as
with the applicable FCC Part 68 rules and requirements
early morning or late evenings.
adopted by the ACTA. A compliant telephone cord and
modular plug is provided with this product. It is designed
to be connected to a compatible modular jack that is also
compliant.
20
...