Log:
valutazioni - 4, GPA: 3.3 ( )

Istruzioni per l'uso DeWalt, Modello D25304

Produttore : DeWalt
File Size : 207.73 kb
File Nome :
Lingua di insegnamento: enesfr
Vai a scaricare



Facilità d'uso


Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. • Avoid prolonged contact with dust power sanding, sawing, grinding, drilling, and other construction Wear protective clothing and wash exposed water. Allowing dust to get into your mouth, eyes, may promote absorption of harmful chemicals. • The label on your tool may include the following and their definitions are as follows: V..........volts Hz........hertz min ......minutes ....direct current ........Class II Construction ........safety alert symbol BPM ....beats per minute A ..........amperes W ..........watts ........alternating current no ........no load speed ..........earthing terminal .../min....revolutions per minute English WARNING: Use of this product will expose you to chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. Avoid inhaling vapors and dust, and wash hands after using. Side Handle FIGURE 1 CAUTION: Hold the side handle and body of the tool firmly with both hands to maintain control of the tool at start up and during use. A side handle is supplied with this rotary hammer. It clamps to the front of the gear case as shown in Figure 1 and can be rotated 360° to permit right or left hand use. The side handle can be tightened by rotating the black plastic portion of the side handle clockwise and loosened by rotating it counterclockwise. Switch (Fig. 2) To start the rotary hammer, depress the trigger switch (A). To stop rotary hammer, release the switch. 3 English FIGURE 2 C B A D25101, D25103 C D25201, D25203, D25303, D25304 A LOCK ON BUTTON (D25101, D25103 ONLY) To lock the trigger switch in the ON position for continuous operation, depress the trigger switch and slide up the lock on button (B). The tool will continue to run. To turn the tool OFF from a locked ON condition, squeeze once then release the trigger. Before using the tool each time, be sure that the lock on button release mechanism is working freely. Do not lock the switch ON when drilling by hand so that you can instantly release the trigger switch if the bit binds in the hole. The lock on button is for use only when the rotary hammer is mounted in a drill press stand or otherwise held stationary. CAUTION: Be sure to release the locking mechanism before disconnecting the plug from the power supply. Failure to do so will cause the rotary hammer to start immediately the next time it is plugged in. Damage or injury could result. 4 VARIABLE SPEED TRIGGER The variable speed trigger switch (A) permits speed control. The farther the trigger switch is depressed, the NOTE: Use lower speeds for starting holes without drilling in metal, plastics or ceramics, or driving are better for drilling in masonry for maximum efficiency. REVERSING ...

Questo manuale è adatto anche per i modelli :
Altri strumenti - D25103 (207.73 kb)
Altri strumenti - D25101 (207.73 kb)
Altri strumenti - 581054-00 (207.73 kb)
Altri strumenti - D25303 (207.73 kb)

Scrivi la tua opinione del dispositivo



Il messaggio
Il tuo nome :
Inserire le due cifre :
capcha





categorie