valutazioni - 0, GPA: 0
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
Doing so could cause the loss of the array configuration or data, or both. Instead, power off both affected controllers, move the drives, and then restart. 4. Known Limitations 4.1 ACU Utility Page 4 Series-2-3-5-Controller_Readme_8_2010.txt o If a non-MaxIQ (generic) SSD is connected to the controller on a lower port number than an Adaptec MaxIQ SDD, you cannot use the ACU utility to add the MaxIQ SSD to the MaxIQ pool. You must use Adaptec Storage Manager. NOTE: Adaptec Q-series controllers do not have this limitation. o On some Intel and IBM systems, when you try to run the ACU utility, this message appears: "Not enough free memory to load the utility! Press any key to attempt loading the utility forcibly OR Wait for the system initialization to be completed [Default]" This is normal. On Intel systems, wait for the system initialization to be completed. Then the ACU will run. On IBM systems, press any key when prompted to load the utility forcibly. o The ACU erroneously displays deleted logical drives in the JBOD list. The logical drive(s) continue to appear in the JBOD list until you delete all of the JBODs. o With some enclosures, the ACU displays incorrect box/slot information for managed disk drives; for example, Exp/Phy instead of Box/Slot. 4.2 AFU Utility o When running the AFU in Menu Mode, you can update (flash) only one controller at a time. You must reboot the system before updating the next controller. o Flashing a 5-series high-port controller (51245, 51645, 52445) with down-level firmware and an older version of the AFU crashes the system. To recover, you must use a Mode 0 reset using the latest firmware version. See the user's guide for details on the Mode 0 method. 4.3 Creating an Array from the Adaptec Installation CD When you create an array with Adaptec Storage Manager in bootable-CD Mode, the maximum size of the array is 2 TB. 4.4 Using the Controller with an Adaptec S50 JBOD Enclosure Temperature warnings from the Adaptec S50 JBOD Enclosure with firmware version T016 are not shown in Adaptec Storage Manager (or on the enclosure). To correct the problem, upgrade to the latest firmware version. 4.5 UnixWare and OpenServer Adding or moving controllers in an existing UnixWare or OpenServer system may cause some device resources to change, which may lead to the operating system being unable to boot. Currently, there is no workaround available in the operating system. Before installing the operating system, make sure all PCI devices are either enabled or installed. 4.6 OpenServer 6.0 Arrays may not be displayed correctly, even after you restart your computer. To resolve the problem: As root, run 'resmgr -r -m vtoc' until it fails. Then, as root, run '/etc/conf/bin/idconfupdate -f'. Then, reboot. 4.7 SuSE Linux Enterprise Server 10 with Service Pack 2 If your boot array is installed on the controller, and the boot Page 5 Series-2-3-5-Controller_Readme_8_2010.txt OS is SLES10 SP2 with driver version 1.1.5-2458, ...
Questo manuale è adatto anche per i modelli :Altri componenti - Adaptec RAID 5805 (20.45 kb)
Altri componenti - Adaptec RAID 5445Z (20.45 kb)
Altri componenti - Adaptec RAID 5445 (20.45 kb)
Altri componenti - Adaptec RAID 5405Z (20.45 kb)