|
Facilità d'uso
this state. 90° 50% 50% 90° 10% 90% Installation and connections Notes • Never give strong force to the lens shift dial as this may cause malfunction. • At the ceiling-mounted projector placement 22 , the relation between the moving direction of the projection position and the turning direction of the lens shift dial becomes contrary from the case of the floor-mounted projector placement. Projector placement angle adjustment (Foot adjuster) CONTENTS 21 The tilt of the projector can be adjusted using the foot adjuster. Adjust this when the highest position by the lens shift dial 20 is insufficient. Refer to “Projection on the screen” 27 , and adjust the foot adjuster after projecting a picture. Installation andconnections Foot adjuster release button Foot adjuster Lift the front of the projector until the desired tilt angle is obtained and hold down the foot adjuster release button. The foot adjuster will extend. Release the button to lock in position. 1 Turn the foot adjuster to make fine adjustment to the height. Turn clockwise to lift up. Turn counterclockwise to lower. 2 Lift up Lower Notes • To put the foot adjuster back, hold down the foot adjuster release button and lower the front slowly. • Be sure to hold the projector when putting the foot adjuster back so as not to let the front fall on your fingers. • Do not tilt the projector at an angle exceeding the range adjustable by the foot adjusters, since the life duration of the lamp may be shortened. . . CONTENTS 22 Ceiling-mounted projector placement CAUTION When a ceiling mount is required, please consult with the dealer. Ceiling-mounted front projection Ceiling-mounted rear projection Viewing a picture projected on the front of the screen from a Viewing a picture projected through the back of the screen from a ceiling installation. ceiling installation. Viewer USB S-VIDEOVIDEOAUDIO COMPUTER ( Y/PB /PR )CONTROL Viewer Translucent screen Perform the “Projection mode” setting on the menu screen for the projection method. 50 Note The relation between the projection size and the distance to the screen is the same as that of the floor-mounted projection mode 18 Installation and connections Connecting a computer You can project the picture from the computer. Check that the power supplies for the projector and for the computer are off before connecting the cables. CONTENTS 23 Installation andconnections COMPUTER connector For use as both analog RGB and Y/PB/PR input. At shipping from factory, it is set for use as analog RGB input. AUDIO jack For use as audio signal of all input sources. RGB cable (supplied) To AUDIO jack Computer To COMPUTER connector Be sure to connect in the proper direction. To monitor port Audio cable (supplied) o3.5mm stereo mini-jack To audio output port USB S-VIDEOVIDEOAUDIO COMPUTER ( Y/PB/PR )CONTROL Notes • The projector...
Questo manuale è adatto anche per i modelli :Proiettori - Conference Room Projectors TLP-250 (1.81 mb)
Proiettori - Conference Room Projectors TLP-251 (1.81 mb)
Proiettori - Conference Room Projectors TLP-551 (1.81 mb)
Proiettori - TLP-250 (1.81 mb)