valutazioni - 0, GPA: 0
(
)
)
|
Foto e specifiche BenQ MW767 |
da questo dispositivo ha anche altre istruzioni :
Proiettori - MW767 (416.18 kb)
Proiettori - MW767 (175.25 kb)
Proiettori - MW767 (2.68 mb)
Facilità d'uso
provides fine color control adjusent to allow for more accurate color reproduction, should
you require it.
Proper color management can only be achieved under controlled and reproducible viewing
conditions. You will need to use a colorimeter (color light meter), and provide a set of
suitable source images to measure color reproduction. These tools are not provided with
the projector, however, your projector supplier should be able to provide you with suitable
guidance, or even an experienced professional installer.
The Color Management provides six sets (RGBCMY) of colors to be adjusted. When you
select each color, you can independently adjust its range and saturation according to your
preference.
If you have purchased a test disc which contains various color test patterns and can be
used to test the color presentation on monitors, TVs, projectors, etc. You can project any
image from the disc on the screen and enter the 3D Color Management menu to make
adjusents.
To adjust the settings:
1.
Go to the PICTURE menu and highlight 3D Color Management.
2.
Press MODE/ENTER and the 3D Color Management page displays.
3.
Highlight Primary Color and press
/
to select a color from among Red,
Yellow, Green, Cyan, Blue, or Magenta.
4.
Press
to highlight Hue and press
/
to select its range. Increase in the range
will include colors consisted of more proportions of its two adjacent colors.
Please refer to the illustration to the right for how the
colors relate to each other.
For example, if you select Red and set its range at 0,
only pure red in the projected picture will be selected.
Yellow
Increasing its range will include red close to yellow and
RED
GREEN
red close to magenta.
5.
Press
to highlight Saturation and adjust
its values to your preference by pressing
/
. Every adjusent made will reflect to the
Magenta
Cyan
image immediately.
For example, if you select Red and set its value at 0,
BLUE
only the saturation of pure red will be affected.
Saturation is the amount of that color in a video
picture. Lower settings produce less saturated colors;
a setting of “0” removes that color from the image
entirely. If the saturation is too high, that color will be overpowering and unrealistic.
6.
Press
to
highlight
Gain and adjust its values to your preference by pressing
/
. The contrast level of the primary color you select will be affected. Every adjusent
made will reflect to the image immediately.
7.
Repeat steps 3 to 6 for other color adjusents.
8.
Make sure you have made all of the desired adjusents.
9.
Press MENU/EXIT to exit and save the settings.
Resetting current or all picture modes
1.
Go to the PICTURE menu and highlight Reset Picture Settings.
2.
Press MODE/ENTER and press
/
to select Current or All.
•
Current: returns current picture mode to the factory preset settings.
•
All: returns all settings, except User 1/User 2 in the PICTURE menu to the
factory preset settings.
42
Operation
... Questo manuale è adatto anche per i modelli :
Proiettori - MX766 (9.5 mb)
Proiettori - MX822ST (9.5 mb)