valutazioni - 1, GPA: 3
(
)
)
|
Foto e specifiche Dyson DC24 |
Facilità d'uso
Some carpets will fuzz if a rotating brushbar is used when vacuuming. If this happens, we recommend vacuuming in bare floors mode and consulting with your flooring manufacturer. Hard floors or carpets the brushbar will always default to ‘on’ (spinning) each time you switch on the machine and recline it for cleaning. the brushbar will automatically stop if it becomes obstructed. if the brushbar stops during use, please refer to the ‘clearing brushbar obstructions’ section. To switch the brushbar off (e.g. for hard floors), recline the machine and turn it ‘ON’, then press the brushbar ‘ON/OFF’ button – the brushbar will stop spinning. Using the tools – High-reach cleaning caution: (i) switch ‘off’ machine before changing tools. (ii) Powerful suction can cause the hose to ‘pull back’ - please take care. 17806_DC24_US_ALL_FLOORS_OPS_MA_ WARNING_UPISSUE.indd 10 5/12/07 13:45:08 (iii) take extra care when vacuuming on stairs; do not work with the vacuum cleaner above you on the stairs. Do not put the vacuum cleaner on chairs, tables etc. (iv) ensure machine is in upright position before using tools. to release the wand, open the wand cap, press button and lift up. Rotate the wand and clip handle into hose. tools can be attached to either the hose or wand. the brushbar will not rotate when the machine is in an upright position. Emptying the Clear binTM caution: (i) switch ‘off’ and unplug machine before emptying the bin. Empty as soon as the dirt reaches the level of the MAX mark – do not overfill. To remove the clear bintm from the machine press the button at rear of carrying handle. to release the dirt, press the button again to open the bin. Please note: (i) Do not use the machine without the clear bintm in place. Cleaning the Clear binTM caution: (i) Do not immerse the whole cyclone in water or pour water into the cyclones. (ii) ensure bin is completely dry before replacing. Please note: (i) Do not use detergents, polishes or air fresheners to clean the bin. (ii) Do not put bin in a dishwasher. Washing your filters caution: (i) Switch ‘OFF’ and unplug machine before removing the filters. (ii) Ensure filters are completely dry before refitting to machine. This machine has two filters, located as shown. It is important to check your filters regularly and wash at least every month according to instructions, to maintain performance. The filter in the ball should be rinsed and tapped out until the water runs clean, then tapped out again to ensure all excess water is removed. This will normally require up to 10 rinse cycles. Please leave to dry completely for 24 hours. Please note: (i) It is normal for this filter in the ball to turn grey in color. The filters may require more frequent washing if vacuuming fine dust. (ii) Do not use detergents to clean the filters. (iii) Do not put the filters in the dishwasher, washing machine, tumble dryer, oven, microwave or near an open flame. Looking for blockages caution: (i) switch ‘off’ and unplug machine before checking for blockages. failure to do so could result in personal injury. (ii) Please ensure machine is upright and switched off before removing hose or airway inspection parts. (iii) beware of sharp objects when clearing blockages. (iv) Refit all parts of the machine securely before using. Please note: (i) Clearing blockages is not covered by your machine’s limited warranty. This machine is fitted with a thermal cut-out. if any part of your machine becomes blocked, it may overheat and then automatically shut off. switch ‘off’ and unplug machine and leave to cool down for at least 60 minutes before attempting to check filters or for blockages. Clear blockage before restarting. SAVE THESE INSTRUCTIONS this aPPliance is intended foR household use onlY 17806_DC24_US_ALL_FLOORS_OPS_MA_ WARNING_UPISSUE.indd 11 5/12/07 13:45:08 SAVE THESE INSTRUCTIONS this aPPliance is intended foR household use onlY Clearing brushbar obstructions caution: (i) switch off and unplug machine before clearing brushbar obstructions. failure to do so could result in personal injury. (ii) if your brushbar is obstructed, it may shut off. if this happens you will need to remove the brushbar as shown and clear any obstructing debris. Refit all parts securely and press the ‘RESET’ button. Dyson customer care thanK You foR choosing to buY a dYson. If you have a question about your Dyson vacuum cleaner, call the Dyson Helpline at 1-886-693-9766 with your serial number and details of where and when you bought the cleaner. Your serial number can be found on the rating plate, which is behind the clear bin.tm Most questions can be solved over the phone by one of our Helpline staff. If your vacuum cleaner needs service, call the dyson helpline so we can discuss the available options. if your machine is under warranty, and it is a covered repair, it will be repaired at no cost. Dyson Helpline call 1-866-693-9766 toll free, 7 days a week. Please register as a Dyson owner thanK You foR choosing to buY a dYson....