valutazioni - , GPA: ( )

Istruzioni per l'uso AEG, Modello SMART 306

Produttore : AEG
File Size : 380 kb
File Nome :

Lingua di insegnamento:

Il documento viene caricato, si prega di attendere

Scarica la tua primo

Il documento viene caricato, si prega di attendere

Scarica la tua primo

D3T Extend the cable and connect to mains. The cleaner is fitted with cable rewind, ensure cable is not twisted before use. (Press foot pedal to rewind. Note: Please hold the plug to prevent it striking you or the machine). lE^ Press the On/Off button to activate the cleaner. lE^ To decrease/increase suction, turn the rolling wheel on the multifunction handle (306;350;360;366). Suction can also be regulated on the hose handle by opening/closing the aperture. 10 w Getting the best results (see page 5) • Carpets: Use the floor nozzle with the lever in horizontal position. • Hard floors: Use the floor nozzle with the lever in vertical position. • Loose rugs/curtains/lightweight fabrics: Reduce the suction power. Use the floor nozzle for loose rugs and the upholstery nozzle for curtains, cushions etc. • Confined areas: Use the crevice nozzle for crevices, corners and radiators. Dustbag indicator and changing the dustbag (see page 5) For peak performance the dustbag must be changed when full. If the dustbag should accidentally get broken in the cleaner, take cleaner to an AEG Service Centre for cleaning. Check the dustbag regularly and replace when necessary. The dustbag indicator window will gradually turn red when filling and completely red when full. To check the dustbag, the cleaner must be switched on, with all attachments connected and off the floor. The dustbag full indicator may signify that the bag is blocked (occasionally caused by very fine dust) which will cause loss of suction and may result in overheating. If this occurs change the dustbag even if it is not full. To change the dustbag W Release catch and swing back lid before removing the dustbag. W Remove the dustbag. W Insert new dustbag by fitting the bag slots over holders. We recommend the dustbag is changed • after using a carpet cleaning powder • if there is a bad smell from the cleaner, then you should also change the filter • Note: Use only AEG original dustbags and filters (ref GR50). Dust bag safety device: To avoid damaging the cleaner do not use it without a dustbag. A safety device is fitted which prevents the cover closing without a dustbag. Do not attempt to force cover shut. '%> Changing the filters (see page 5) There are two filters inside your cleaner. Never use the cleaner without the filters in place. To clean Motor Protection filter The Motor Protection filter should be cleaned when dirty. Release catch, remove the lid and the filter. Wash the filter in warm water. Allow to dry and re-insert the clear filter. Close the lid. To change Micro filter The Micro filter should be changed with every fifth dustbag. Release catch, open the filter cover and remove filter with grill. Take the filter out of the grill. Insert new filter into the grill, put it back into the cleaner. Close the cover. To change HEPA filter (366) Release catch, open the filter cover. Take the filter with grill out of the cleaner. Insert new filter with grill, and c...