valutazioni - , GPA: ( )

Istruzioni per l'uso Black & Decker, Modello BLACK AND DECKER CORDLESS HAND VAC PHV1810

Produttore : Black & Decker
File Size : 672.33 kb
File Nome : c023359c-d445-43a3-aa88-52c969d3f510.pdf

Lingua di insegnamento:

Il documento viene caricato, si prega di attendere

Scarica la tua primo

Il documento viene caricato, si prega di attendere

Scarica la tua primo

• Do not insert accessories when unit is running. • Shock Hazard. Do not handle plug or • Do not put any object into Do not use with any openings free of dust, lint, hair, and anything that may reduce • Fire Hazard. Do not vacuum burning or smoking matches or hot ashes. • Do not use on or near hot surfaces. • Use extra caution when cleaning on stairs. • This appliance is intended for household use use. • Use only as described in this manual. Use only manufacturer .s recommended attachments. • Unplug the charger from outlet before any routine cleaning • This product includes rechargeable nickel cadmium batteries. Do not incinerate batteries as they will explode at high temperatures. • Leaks from battery cells can occur under extreme conditions. If the liquid, which is a 20-35% solution of potassium hydroxide, gets on the skin (1) wash and water or (2) neutralize with a mild acid such as lemon juice or If the liquid gets into the eyes, flush them immediately with clean water for a minimum minutes. Seek medical attention. • Do not look into the air vents when the unit is switched on, as sometimes there is a possibility of small debris being discharged from the air vents, especially after cleaning / replacement of the filters as debris inside the unit can be disturbed. SAVE THESE INSTRUCTIONS Symbols • The label on your tool may include the following symbols. The symbols and their definitions are as follows: V..................volts A ..................amperes Hz................hertz W..................watts min ..............minutes ................alternating current ............direct current no ................no load speed ................Class I Construction ..................earthing terminal ................safety alert symbol (grounded)................Class II Construction .../min or rpm ........revolutions or reciprocation (double insulated) per minute • When using an extension cord, be sure to use one Minimum Gauge for Cord Sets heavy enough to carry the Volts Total Length of Cord in Feet 120V 0-25 26-50 51-100 101-150 current your product will (0-7,6m) (7,6-15,2m) (15,2-30,4m) ( 30,4-45,7m) draw. An undersized cord 240V 0-50 51-100 101-200 201-300 will cause a drop in line (0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m) voltage resulting in loss of Ampere Rating power and overheating. More Not more American Wire Gauge The following table shows Than Than the correct size to use 0-618 16 16 14 depending on cord length 6 - 10 18 16 14 12 and nameplate ampere 10 - 12 16 16 14 12 rating. If in doubt, use the 12 - 16 14 12 Not Recommended next heavier gauge. The smaller the gauge number, the heavier the cord. 2 3 4 5 Assembly Adjusting the dust collector (fig. A - C) The dust collector (1) has a brush that can be folded forward for dusting and upholstery cleaning. • The dust collector (1) is stored under the appliance. To adjust for use, unplug the appliance from the charger (7). • Press the pivot lock button (3) and rotate the dust collector (1) to the required position. • Release the pivot lock button (3) to lock the dust collector in position • The dust collector can be extended by pulling the dust collector extension (9) until it locks into position. • The extension can be retracted by pressing the button (10) and pushing the extension back into the dust collector. • The dust collector should be returned to the storage position under the appliance after use and while charging the appliance. Use • Before first use, the battery must be charged for at least 24 hours. • Plug the appliance into the charger whenever power gets low. Charging the battery (fig. D) • Make sure that the appliance is switched off. The battery will not be charged with the on/off switch (4) in the on position. • Plug the appliance into the charger (7) as shown. The charging indicator wil be lit. • Leave the appliance on charge for at least 24 hours. While charging, the charger may become warm. This is normal and does not indicate a problem. The appliance can be left connected to the charger indefinitely. The charging indicator will be lit as long as the appliance is connected to the plugged-in charger. WARNING:Do not charge the battery at ambient temperatures below 39°F (4°C) or above 104°F (40°C). Switching on and off (fig. E) • To switch the appliance on, slide the on/off switch (4) forward to position I. • To switch the appliance off, slide the on/off switch (4) back to position 0. Optimizing the suction force Rotating the bowl (fig. A) agitates the filter to remove dirt; however, in order to keep the suction force optimized, the dust container and filters must be cleaned regularly. Cleaning the dust container and filters (fig. F - K) There are two methods of cleaning the bowl, a quick empty method and a thorough clean method. For the quick empty method use the following instructions. • Press the release latch (6) and open the container door (5) (fig. F). • Empty the dust container (11). • Close the dust container door (5). Mak...