valutazioni - , GPA: ( )

Istruzioni per l'uso Bissell, Modello 1718

Produttore : Bissell
File Size : 1.96 mb
File Nome : 0f4fe079-26be-4201-96b6-86c4c60c9827.pdf

Lingua di insegnamento:

Il documento viene caricato, si prega di attendere

Scarica la tua primo

Il documento viene caricato, si prega di attendere

Scarica la tua primo

Refill if needed. cleaning solution and remove any Never run dry. surface soil. Using the brush before applying solution can push soil more deeply into carpet. Spot cleaning upholstery 1. Check manufacturer’s tag before cleaning. “W” or “WS” on the tag means you can use your Spot Lifter. If tag is coded with an “S” (with diagonal strike-through), or says “Dry Clean Only,” do not proceed. 2. If manufacturer’s tag is missing or not coded, check with your furniture dealer. NOTE: If possible, check upholstery stuffing. Colored stuffing may bleed through fabric when wet. 5. Adsdfdd ghg bvhcvbbj jkn hnbj jkvhgcghhjj fhl kllgh Manufacturer’s Tag 800.237.7691 7 ug603-5410_1719_806.indd 7 9/25/06 1:07:39 PM Operations (continued) Cleaning spills from hard surfaces 1. Turn power switch “I” (ON). 2. Press front of Spot Lifter firmly against hard surface to suction up spill. 3. Press trigger to spray cleaning solution. 4. Press front of Spot Lifter firmly against hard surface to suction cleaning solution, as in step 2 above. NOTE: If the Spot Lifter stops spraying, turn unit “O” (OFF) and check the cleaning solution level in the solution tank. Refill if needed. Never run the unit without water or cleaning solution. Maintenance and care Machine care 1. Turn the power switch to the “OFF” position. ( O ) 2. Carry the Spot Lifter to the sink or drain. To empty the collection tank 1. Remove the collection tank by pressing the tank release button at the top of the tank. The tank will pivot out on a “hinge” at the bottom of the unit. 2. Remove the tank plug by turning approximately 1/4 turn counterclockwise and lifting out. Empty tank. 3. Thoroughly rinse the collection tank with clean water. Be sure to rinse nozzle area. 4. Replace tank plug and turn approximately 1/4 turn clockwise, until snug. 5. To replace the tank, pivot bottom of tank back into "hinge" and tilt up to handle. Press the tank release button, and snap the tank into place. Test for a secure fit before using. NOTE: Check the solution tank. If a significant amount of BISSELL Little Green formula/water remains, you may leave it in the solution tank for your next cleaning task. 2. 3. 2. 3. Tip: Check spray nozzle for accumulated dirt or debris. If necessary, clean with soft bristle brush. 8 800.237.7691 ug603-5410_1719_806.indd 8 9/25/06 1:07:41 PM Machine storage1. Machine storage1. Maintenance and care (continued) Clean exterior surface of Spot Lifter with a soft cloth dampened with water only. Do not use a WARNING: strong detergent or other cleaners as this may This product contains a damage the finish. rechargeable nickel cadmium battery (sometimes referred 2. Store Spot Lifter in a protected dry area, at room to as a “Ni-Cad” battery) temperature (40° - 110°F). pack. The average life of a Ni-Cad battery is 5-7 years, depending on frequency of Battery removal and disposal use. According to Federal 1. Important: Unplug charger. regulations, proper removal and disposal of Ni-Cad 2. Remove tanks (front and rear) and discard. batteries are required. 3. Remove screws (6) holding product housing together. 4. Use screwdriver to score rating label on bottom of unit. 3. 5. Separate housings and locate battery pack in bottom/ center of unit. 6. Remove wire connectors from the battery pack. 7. Keep battery pack together - DO NOT separate individual batteries. For specific disposal instructions of batteries, please contact: RBRC (Rechargeable Battery Recycling Corporation) 1-800-822-8837. 8. Discard remainder of product. WARNING: To reduce the risk of fire, electric shock or injury, Troubleshooting unplug appliance fromoutlet before servicing. Reduced Suction / No Suction Possible Cause Remedies 1. Collection tank is full 1. Empty collection tank 2. Collection tank drain plug is loose 2. Check plug for snug fit 3. Batteries weak/undercharged 3. Recharge according to instructions 4. Collection tank not properly installed 4. Snap tank into place Screws 800.237.7691 9 ug603-5410_1719_806.indd 9 9/25/06 1:07:42 PM Troubleshooting (continued) Reduced Spray / No Spray Possible Cause Remedies 1. Solution tank is empty 1. Refill solution tank 2. Pump not primed 2. While Spot Lifter is turned on, press spray trigger and gently rock Spot Lifter back and forth 3. Batteries weak/undercharged 3. Recharge according to instructions 4. Spray tip clogged 4. Rinse tip with clean water Spot Lifter is not powered / underpowered Possible Cause Remedies 1. Charger / plug not connected 1. Make sure charger plug is completely plugged into wall outlet and charging cord is completely plugged into port on back of unit. Make sure Spot Lifter is stored with power switch in "O" (off) position Spot Lifter will not charge Possible Cause Remedies 1. Charger / plug not connected 1. Make sure charger plug is completely plugged into wall outlet and charging cord is completely plugged into port on back of unit. Make sure Spot Lifter is stored with power switc...