valutazioni - 3, GPA: 4
(
)
)
|
Facilità d'uso
See below for detailed cleaning instructions. Press and hold Spray Trigger—spray will start in a few seconds. Raise the tool slightly to check for spray. Hold the tool approximately 1” above the soiled surface. Depress the Spray Trigger to apply the cleaning solution to the soiled area. Using the brush on the tool, gently scrub the area to be cleaned. Note: If using the TurboBrush, the switch should be in the “BRUSH” position. This activates the brush only. For thorough cleaning, spray additional solution, while the brush and suction are in contact with the surface. Apply downward pressure on the tool and pull it toward you. The suction will remove the dirt and cleaning solution. Continue until no more dirt can be removed. Note: If using the TurboBrush, move the switch to the “SUCTION” position. This activates the suction to remove the dirt and cleaning solution. Move the switch back to the “BRUSH” position for additional brushing action. As a final step, use “drying strokes” (by not depressing the Spray Trigger) to remove as much liquid/moisture as possible. Repeat this step as often as necessary. Note: If using the TurboBrush, move the switch to the “SUCTION” position. This activates the suction to remove the dirt and cleaning solution. Getting Ready Continued How To Deep-Clean Carpet and Upholstery 5. 6. 1. 2. 3. 4. 5. 8 Power Switch Heat Indicator Light Heater Switch 5 6 BRUSH SUCTION 3 IMPORTANT: Check the manufacturer’s tag before cleaning upholstery. “W” or “WS” onthe tag means you can use your LittleGreen. If tag is coded with an “S” (with diagonal strike-through), or says“Dry Clean Only,” do not proceed. Ifmanufacturer’s tag is missing or not coded, check with your furniture dealer. Tip: Deep cleaning stairs and high- traffic areas on a regular basis can prolong carpet life. Tip: Check upholstery stuffing before cleaning. Colored stuffing may bleed through the fabric when it becomes wet. Turn Power Switch to OFF position. Note: If your unit has a Built In Heater turn the Heater Switch off. Unplug Power Cord from outlet. Note: If a significant amount of Little Green formula/water remains, it is all right to leave it in the Clean/Solution Tank for your next cleaning task. Empty and rinse the Dirty/Collection Tank after each use, OR when dirty water reaches the indicated maximum fill line. To remove the tank, lift up the Dirty/Collection Tank retainer lever and remove the tank from the unit. Disconnect the cleaning tool from the Spray Trigger by pushing down on button lock and pulling straight off (Do NOT twist tools to remove them). Once removed from the Spray Trigger, all tools can be cleaned by rinsing under clean running water. The TurboBrush tool’s switch must be in “SUCTION” position before rinsing under clean running water. Check Spray Nozzle for accumulated dirt or debris. If necessary, clean with soft bristle brush. Wipe all surfaces with a soft cloth. Wrap Power Cord around the Cord Wrap on the back of the Little Green. Wrap Vacuum Flex Hose around the base of the unit and secure the Spray Trigger. Store unit in protected, dry area, at room temperature (40. to 110.F). Note: For Little Green TurboBrush Models, onboard storage for the TurboBrush Tool has been provided on the back of the unit. Attach the TurboBrush to the unit by pressing it onto the holder firmly until the button snaps into hole. When You’re Finished Tip: Before turning off the Little Green, vacuum up clean water to thoroughly rinse out the interior of the Vacuum Flex Hose. Then, lift the cleaning tool and point it upwards to drain any remain- ing water into the Dirty/Collection Tank. WARNING: Keep spray away fromface. Failure to do so may result in personalinjury. Storing Your Little Green 1. 2. 3. 4. 5. 6. 1. 2. 3. 4. Retainer Lever 3 9 When You’re Finished Tip: Before turning off the Little Green, vacuum up clean water to thoroughly rinse out the interior of the Vacuum Flex Hose. Then, lift the cleaning tool and point it upwards to drain any remain- ing water into the Dirty/Collection Tank. WARNING: Keep spray away fromface. Failure to do so may result in personalinjury. Storing Your Little Green 1. 2. 3. 4. 5. 6. 1. 2. 3. 4. Retainer Lever 3 9 Troubleshooting Troubleshooting Remedies Check electrical plug Replace household fuse or reset breaker Remedies Clean Spray Nozzle Check/Refill Tank Clean insert at bottom of Clean/Solution Tank Gently lift Clean/Solution Tank up and down while depressing the Spray Trigger OR Gently squeeze clean tank while depressing Spray Trigger Remedies Reposition Upholstery/Carpet Tool on surface, follow recommended cleaning procedures Empty Dirty/Collection Tank Replace with new Brush Lift Tool and point upwards to allow water in Hose to flow into the Dirty/Collection Tank Use BISSELL Little Green formula only Remedies Reposition switch to Brush position Remedies Reposition switch to suction position Cleaner won’t run. Possible Causes Power cord not plugged in Blown fuse/tripped breaker Reduced...