Read all the warning and safety issues below before you use the robot. 1.0.1 Danger • Do not immerse the robot, the base station or the adapter in water or any other liquid. • Do not use the robot on wet floors or in places where there is a risk of contact with water or immersion in water. • Never suck up flammable substances and do not suck up ashes until they are cold. • Do not use the robot in humid surroundings like bathrooms. • Do not use the robot in hazardous areas such as close to firepl

2 Insert two AAA 1.5-volt alkaline batteries into the battery compartment inside the handle. Note: Make sure that the - and + poles point in the right direction. 3 Reattach the battery compartment lid (1) and fasten the screw with a screwdriver (2). Preparing for use Ergonomic advice ComfortControl handgrip (specific types only) -The unique Comfor tControl handgrip is ergonomically designed to give you sufficient comfor t during vacuum cleaning. -To gain optimal benefit from this handgrip, it is

1 The suction power is insufficient. A The suction power may be set to a low setting. - Set the suction power to a higher setting. B The nozzle, tube or hose may be blocked up. -To remove the obstruction, disconnect the blocked-up item and connect it (as far as possible) the other way around. Switch on the vacuum cleaner to force the air through the blocked-up item in opposite direction. C The dustbag may be full. -Empty the reusable dustbag (specific types only) or replace the dustbag. D The fi

The brush strip disappears into the nozzle housing. , Parquet nozzle (specific types only) -The parquet nozzle is designed for gentle cleaning of hard floors. Crevice tool, small nozzle and small brush 1 Connect the crevice tool (1), the small nozzle (2) or the small brush (specific types only) (3) directly to the handgrip or to the tube. accessory holder 1 2 Snap the accessory holder onto the handgrip. Snap two accessories into the accessory holder: English 11 -Crevice tool and small nozzle. No

adjusting suction power You can adjust the suction power with: -the suction power slide on the handgrip. -the electronic suction power control on the vacuum cleaner. Cleaning and maintenance The plug must be removed from the socket-outlet before cleaning or maintaining the appliance. Do not clean any part of the vacuum cleaner in the dishwasher. If necessary, clean the parts with a moist cloth. 1 Clean the appliance with a damp cloth. Emptying the dust container -- For optimal performance, empty