valutazioni - 3, GPA: 3
(
)
)
|
Facilità d'uso
is located on the bottom of the unit. •To disconnect the AC power cord (mains lead), pull it out by the plug, not the cord. • Do not leave the unit in a location near a heat source such as a radiator or air duct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. • To reduce the risk of fire, do not cover the ventilation of the apparatus with newspapers, tablecloths, curtains, etc. And do not place lighted candles on the apparatus. • Allow adequate air circulation to prevent internal heat build-up. Do not place the unit on a surface (a rug, a blanket, etc.) or near materials (a curtain) which might block the ventilation holes. • To clean the casing, use a soft cloth dampened with a mild detergent solution. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Troubleshooting Should any problem persist after you have made the following checks, consult your nearest Sony dealer. The clock does not show the correct time. • Has an electrical power outage occurred? The CD, radio or buzzer alarm does not sound at the preset alarm time. • Is the ALARM indicator light on? The radio alarm is activated but no sound comes on at the preset alarm time. • Is the TUNING dial set to a receivable radio station? • Has VOLUME been adjusted ? The CD player does not operate. • Did you close the CD lid? • Did you place the disc correctly? The disc should be placed with the labeled side up. • Dusty or defective disc — Clean the disc with an optional cleaning cloth. Wipe the disc from the center out. •Take out the CD and leave the CD compartment open for about an hour to remove moisture condensation. Sporadic loss of sound in CD operation. • Dusty or defective disc — Clean or replace the disc. •Volume too high — Reduce the volume. • Strong vibration. There is no sound or sound output is low by pressing the AUDIO IN button. • Is the AUDIO IN indicator light on? • If the volume of the optional component is low, turn up the volume on the component. The radio gets interference. •When used near electrical devices, move them away or turn off their power. Specifications CD player section System: Compact disc digital audio system Laser diode properties: Emission duration: Continuous Laser output: Less than 44.6 .W (This output is the value measured at a distance of about 200 mm from the objective lens surface on the optical pickup block with 7mm aperture.) Frequency response: 20 - 20 000 Hz+1 – 2 dB Wow and flutter: Below measurable limit Radio section Frequency range: FM: 87.5-108 MHz AM: 530-1 710 kHz General Time display: 12-hour system Speaker: 57 mm (2 1/4 inches) dia., 8 . Input: Audio In jack (stereo minijack): minimum input level 245 mV, impedance 47 k. Power outputs: 0.7 W + 0.7 W (at 10% harmonic distortion) Power requirements: 120 V AC, 60 Hz Dimensions: Approx. 190 . 93 . 222 mm (w/h/d) (Approx. 7 1/2 . 3 2/3 . 8 3/4 inches) incl. projecting parts and controls Mass: Approx. 1.5 kg (3 lb 5 oz) Supplied accessories: audio cable (1) (ICF-CD815 only) Design and specifications are subject to change without notice. Halogenated flame retardants are not used in printed wiring boards. Changing the Brightness of the clock display Slide BRIGHTNESS to select H(high), M(middle) or L(low) for the display according to your preference. Setting the clock 1 Plug in the unit. The display will flash “12:00”. 2 Press CLOCK SET for a few seconds. The hour will start to flash in the display. 3 Press TIME SET + or – until the correct hour appears in the display. 4 Press CLOCK SET once. 5 Repeat steps 3 and 4 to set the minute. After setting the minute, press CLOCK SET to start the counting of the seconds. •To set the current time rapidly, hold down TIME SET + or –. • During PM hours, the indicator lights up. • In step 5, when you press CLOCK SET after the minute setting to activate the clock, the seconds start counting from zero. Playing a CD An 8 cm (3-inch) CD can be played without an adaptor. 1 Pull Z PULL OPEN to open the CD compartment lid and place a disc. 2 Close the CD compartment lid. 3 Press CD u. TRACK “01” appears in the display to indicate that track 1 of the CD is playing. After you press CD u, it takes about 10 seconds before the music starts. The indication in the display returns to the current time a few seconds after the music starts. 4 Turn VOLUME to adjust the volume. To Press Pause CD u Resume play after pause CD u again Locate the beginning of .** the current track (AMS*) Locate the next track >** (AMS) Go back at high speed Hold down .** Go forward at high speed Hold down >** Locate the previous track . repeatedly** (AMS) Locate the succeeding > repeatedly** track (AMS) Stop play x OFF * AMS = Automatic Music Sensor **These operations are possible during both play and pause. • During CD playback, every time you press TRACK, the track number appears in the display for a few seconds. About CD-Rs/CD-RWs This unit is compatible with CD-Rs/CD-RWs bu...
Questo manuale è adatto anche per i modelli :ricevitori radio - DREAM MACHINE ICF-CD814 (617.09 kb)