valutazioni - 0, GPA: 0
(
)
)
|
Facilità d'uso
Deactivate the App’s link function to stop the pop-up message. . To deactivate the App’s link function: Remove your iPod touch/iPhone from the Dock connector. Press . (to enter the function for iPhone). Press and hold . then OFF on the unit at the same time for at least 2 seconds. (“OFF” appears in the display to show that the App’s link function has been deactivated.) . To re-activate the App’s link function, repeat the above steps. (“On” appears in the display to show that the App’s link function has been activated.) General information Replacing the battery of the unit 1 Keep the AC adaptor connected to the wall outlet and unit, then remove the screw of the battery compartment on the bottom of the unit, then open the battery compartment lid. 2 Remove the old battery and insert a new one in the battery compartment with the . side facing up. CR2032 3 Replace the battery compartment lid and tighten the screw. 4 Press ., FM/AM, AUDIO IN or SNOOZE/ BRIGHTNESS on the unit to turn “.” off in the display. Notes . When you replace the battery, do not disconnect the plug from the AC outlet. Otherwise, the current date, current time, alarm and station presets will be erased. . If you are not going to use the remote for a long time, remove the battery to avoid any damage that may be caused by leakage or corrosion. Troubleshooting Should any problem persist after you have made the following checks, consult your nearest Sony dealer. General The power does not turn on when the AC adaptor is connected. . Make sure the AC adaptor is connected to the wall outlet firmly. There is no sound. . Make sure that the unit is connected to the AC power, and the optional component is turned on. . Adjust the volume using VOL + or –. . Make sure that the optional component is correctly connected to the unit. The sound is low. . Adjust the volume using VOL + or –. The sound is distorted. . Deactivate the equalizer function of the connected optional component. . Lower the volume of the unit. Sound skips or noise is heard. . Make sure that the optional component is correctly connected to the unit. . Make sure that the optional component is not near a television. . When the optional component is not in use with the unit, disconnect the audio connecting cable from the AUDIO IN jack. The radio function of a connected optional component does not work. . When an optional component equipped with radio or one segment tuner is connected to the unit, its reception sensitivity may be poor, resulting in no radio function. Noise is heard. . Ensure that the unit is not near in-use portable phones, etc. . Disconnect the audio connecting cable from the AUDIO IN jack when not in use. The clock flashes “AM 12:00” or “0:00” due to a power interruption. . The battery is low. Replace the battery. Remove the old battery and install a new one. The alarm of radio...