valutazioni - 3, GPA: 4.7
(
)
)
|
Facilità d'uso
If the Backup Battery has been installed and a power failure occurs or the AC adaptor is accidentally disconnected, the display backlight will not remain lit, but current time and alarm time settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings. 1. Please make sure the AC adaptor is connected. Otherwise all settings may be lost during battery replacement. 2. Open backup battery compartment door located on the backside of the unit. 3. Insert one CR2032 button cell battery, checking that the polarity (+ and – sides of the battery) matches the drawing in the battery compartment. Close the compartment door. Note: Make sure you dispose of batteries properly (see your local regulations). Installing Backup Battery 3 Setting Up the iH110 Setting Up the iH110 Setting the Clock Time Note: Press the Clock Adj. Button once during normal operation to view the current time display format (12 hour or 24 hour format). 12 hour is the default format. 1. Press and hold the Clock Adj. Button for 2 seconds until the display flashes. Press the UP or DOWN Button until the current time is displayed. 2. For 12 hour or 24 hour time format setting: Press the Alarm Set Button during time setting to set 12-hour or 24-hour display format. Remember to set the correct AM or PM time (an icon to the right of the time display is the PM indicator; there is no AM indicator). Note that the PM indicator will not appear when using 24 hour display mode. 3. Press the Clock Adj. Button again to confirm the clock setting. You should hear 2 beeps indicating the clock time is set. 4. During daylight saving time, set the DST Switch located on the back of the unit to +1 to advance the time one hour. The DST Icon will appear on the display to indicate DST is on. Set the switch to -1 to set the time back one hour at the end of daylight saving time. Charging your iPod Note: Please make sure you are using the correct insert for your iPod (see page 1) and that it is properly docked into the iH110. Failure to do so may damage your iPod. 1. While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). The iH110 will not overcharge your iPod. Note that other non-docking iPods will NOT charge. 4 Listening to your iPod Listening to your iPod 1. Dock the already playing iPod. The iH110 will automatically turn on and you will hear the music playing from your iPod. The will appear at the left lower corner the display, indicating iPod playing mode. For enhanced bass, slide the EXB Expanded Bass Switch located on the back of the unit to the ON position. Note: If the playing song/music loudness is too low on the iPod, the iH110 may not detect that the iPod is in play mode. Press the on the iPod to play it. 2. Press the and Buttons to adjust the system volume. 3. Press the UP or DOWN Button to go to the next or previous track. Press and hold while a track is playing for high speed forward or reverse music search of the current track. 4. To turn the iH110 OFF, press the Power Button. Your iPod will continue charging while in the dock. Listening to FM Radio For best reception, extend the FM antenna away from unit and adjust as needed. Do not alter antenna. 1. Press the Power Button to turn on the unit. Press the Mode Button until the radio icon appears. 2. Press the UP or DOWN Button to tune in the desired FM station. Press and hold to seek the next clear FM stattion. 3. Press the and Buttons to adjust the volume. 4. To turn the iH110 OFF, press the Power Button. Listening to a non-docking iPod or other portable audio device You can play an iPod without a docking port or other MP3 player or portable audio device through the iH110 via the Line-in Jack. 1. Plug one end of an audio patch cord (available at into the headphone or line-out jack on your device and the other end of the patch cord into the iH110 Line-in Jack, located on the back of the unit. 2. Press the Power Button to turn the iH110 on. Press the Mode Button until the icon appears at the lower left corner the display, indicating Line-in playing mode. 3. Turn on and play your device. 4. Press the and Buttons to adjust the system volume. You may need to adjust your device volume, too. 5. To turn othe iH110 OFF, press the Power Button. Please remember to turn off your device, too. 5 Alarm Operation Alarm Operation The iH110 Home System for iPod features “Sure Alarm”. If a power failure occurs or the AC adaptor is accidentally disconnected, the unit will change to buzzer alarm to wake you up (provided you have installed backup battery). This unit also features Gentle Waking, which gradually increases the volume of whatever alarm you set. NOTE: TO WAKE TO iPod, YOUR iPod MUST BE PROPERLY DOCKED AND OFF (NOT IN PLAY MODE) OR NO ALARM WILL SOUND. You CANNOT wake to Line in audio devices. Setting the Alarm 1. Press and hold the Alarm Set Button until the display flashes. Press the UP or DOWN Button until the d...
Questo manuale è adatto anche per i modelli :ricevitori radio - iH110 (136.5 kb)