valutazioni - 2, GPA: 4
(
)
)
|
Facilità d'uso
Alternate Power Supplies may be substituted. Model S1460, International AC Adapter/Recharger (110/220V, 50/60Hz). Model S1462, 12 Volt DC adapter (automotive cigarette lighter plug-in). Model S1465, NiCad Battery Pack. TO INSTALL OR REPLACE BATTERIES Remove all plugs from amplifier. Slip a fingernail under battery door, and slide it out. Lift out battery holder from amplifier. Insert 10 new Alkaline “D” cell batteries. Be careful to observe polarity. Carefully replace battery pack. Replace battery door. Do not mix battery types or attempt to recharge alkaline batteries - equipment damage, safety hazard or fire could result. TO OPERATE: Plug microphone into DYNAMIC Microphone jack. Plug speaker leads into SPEAKER jacks. Turn Amplifier on (switch is located on the front of the amplifier). The red light will go on, showing that power is available. Rotate VOLUME control knob to obtain desired loudness level throughout the coverage area. ON-OFF When switch is in the ON position, the red light will be on. Connection for optional adapters: • S1460 International AC Adapter/Recharger • S1462 12 Volt DC (automotive cigarette lighter) Adapter AUX OUT Connection for 12 to 15V DC accessory VOLUME Rotate clockwise to increase amplification. DC IN MICROPHONE INPUTS There are three microphone inputs, which can be used simultaneously: DYNAMIC - for standard dynamic cartridge microphones CONDENSER - for electret or condenser microphones, which require phantom power (supplied from the amplifier) WIRELESS - accepts line-level output from wireless microphone receiver (AmpliVox S1600 or equivalent) LINE IN L+R (SEPARATE-COMBINED) Combines the separate left and right AUX LINE IN channels. This combined signal will be amplified and appear on both the LEFT and RIGHT channels of the SPEAKER and LINE OUT OUTPUTS. AUXILIARY If you desire to add pre-recorded music or sound effects during your presentation, just plug your CD player, tape player or computer sound card into the LINE IN jack. The LINE IN also has its own VOLUME and TONE control knobs, so that you may adjust the volume and tone to the appropriate level. OUTPUT If you desire to tape record your speech or program, (using cable with standard phono plug) connect the LINE OUT on the amplifier to the input on the tape recorder. ANTENNA [SW805A] Jack for wireless antenna. (Antenna supplied on ‘C’ Channel for mounting on either side of amplifier or use Velcro for optional mounting locations.) INTERNAL WIRELESS RECEIVER[SW805A] (on right side of case) Power on and off and Frequency A-B switches. Frequency should match wireless transmitter SPEAKERS Two separately amplified spe...
Questo manuale è adatto anche per i modelli :Ricevitore e l - S230A (100.81 kb)