valutazioni - 0, GPA: 0
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Ricevitore e l - STR-DA3200ES (7.27 mb)
Ricevitore e l - STR-DA3200ES (7.81 mb)
Ricevitore e l - STR-DA3200ES (12.18 mb)
Facilità d'uso
5 Press ./. repeatedly to select “AUTO CAL START,” then press to start the measurement. Measurement starts in five seconds. A countdown appears on the TV screen. While the time is counting down, stand away from the measurement area to avoid measurement error. 6 Measurement starts. The measurement process will take approximately 30 seconds. Wait until the measurement process completes. To cancel the auto calibration Auto calibration is cancelled when you change the volume, switch functions, change the speaker setting of the receiver, or connect headphones. 3: Confirming/saving the measurement results 1 Confirm the measurement result. When the measurement ends, a beep sounds and the measurement result appears on the display. Measurement results Display Explanation When the measurement process completes properly COMPLETE Proceed to the step 2. When the measurement process fails ERROR CODE ... See “When error codes appear.” 2 Save the measurement result. Press ./. to select “SAVE EXIT,” then press to enter. For details on the measurement results, refer to “7: Calibrating the appropriate settings automatically (AUTO CALIBRATION)” in the operating instructions. Results Parameter When error codes appear Try remedies and re-perform the auto calibration. • CODE 31 Press , then retry the measurements from step 1 of “Performing auto calibration.” • CODE 32, 33 Press , then press ./. to select “YES,” then press . Re-perform the measurements from step 5 of “Performing the auto calibration.” Error Code Cause and remedies CODE 31 SPEAKERS (OFF/A/B/A+B) is set to OFF. Set it to others and re-perform the auto calibration. CODE 32 None of the speakers were detected. Make sure that the optimizer microphone is connected properly and reperform the auto calibration. If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected. CODE 33 (F) None of the front speakers are connected or only one surround speaker is connected. CODE 33 (SR) • Either the left or right surround speakers is not connected. • Surround back speakers are connected even though surround speakers are not connected. Connect the surround speaker to the SURROUND terminal. CODE 33 (SB) The surround back speaker is connected only to the SURROUND BACK SPEAKERS R terminal. When you connect only one surround back speaker, connect it to the SURROUND BACK SPEAKERS L terminal. Setting up other components You should set up each component so that take out sound is output from speakers correctly when you play back a connected component. The following case describes Sony components. Refer to the operating instructions supplied with each component. Sony Super Audio CD player Select a suitable playback area (multi-channel or 2 channel). Sound may come out from only the front speaker left/right when 2 channel is selected. Sony DVD player 1 Select “AUDIO SETUP” on the setup display of the DVD player. 2 Set “AUDIO DRC” to ...