Wash spreader after each use. Lubricate axle bearings with light oil. Store in a dry place. Questions, Comments, Information Call the toll-free Scotts Consumer Helpline: 1.800.543.TURFor visit Scotts No-Quibble Guarantee ® If for any reason you, the consumer, are not satisfied after using this product, you are entitled to get your money back. Simply send us proof of purchase and we will mail you a refund check promptly. The Scotts Company 14111 Scottslawn Rd. Marysville, Ohio 43041 Dedicated ToA

Adjust the micrometer setting CALIBRATION 2. Squeeze the trigger against LINE 3. The front edge of the shutoff bar aligned with the calibration line engraved bottom of the hopper. 4. To adjust alignment, use a small wrench black calibration screw at the lower end wire leading from the micrometer insert. Spend a few minutes on maintenance after each use 2. After each use, wash thoroughly to remove all material clinging to the spreader. Hot water may be required at times to remove stubborn residue

Remove spreader and components from carton. Place Hopper on it’s front panel, insert two (2) 1/4-20 X 1/2” Hex Head Bolts through the Leg, flattened end of Handle Brace, and holes in Hopper as shown. Install Lockwashers and Nuts but do not tighten. Repeat on opposite side. 1/4-20 X 1 1/2” Hex Bolt Nut Lock Washer 3. Install Control Tube between the Control Tube Braces and secure with (2) 1/4-20 X 1 1/2” Hex Bolts, Lockwashers, and nuts. 1/4” D. Clevis Cotter Cotter Control Tube Brace 5. Slide th