valutazioni - 5, GPA: 4.8 ( )

Produttore : Hans Grohe File Size : 4.6 mb File Nome : hruh0107.pdf Lingua di insegnamento:

Make sure that you have all tools and supplies needed to complete the installation. Technical Information Recommended water pressure 14.7 - 72.5 psi Max. water pressure 147 psi Recommended hot water temp. 120.. - 140.. F* Max. hot water temp 165..F* Hole size in mounting surface 1 1/4” valves, 1 3/8” spout Max. mounting surface depth 1 1/2” Flow rate 2.2 gpm Requires 1/2” supply lines (not included) *Please know and follow all applicable local plumbing codes when setting the temperature on the water heater. In Massachusetts, the water heater may be set no higher than 112oF. Installation Install the hot and cold valves Install the mounting nut, metal washer and the fiber washer on the valve. Insert the valve through the hole in the deck. The hot valve is marked with a red dot. Install the stop ring on the valve. Thread the mounting plate on the valve until the stop ring stops it at the proper height. Rest the valve on the mounting surface. Turn the valves so that the outlets point toward the center. Tighten the mounting nut. Tighten the tensioning screws. Install the spout Swing C and Limbo C only: Place the spout, deco ring, and sealing ring on the mounting surface. All other models: Place the spout and sealing ring on the mounting surface. All models: Install the mounting flange. Thread the collar onto the stud and tighten. Install the connecting hoses Push a compression nut and ferrule over the end of the connecting hose. Push the end of the hose into the valve outlet. Tighten the compression nut wrench tight. Do not allow the connecting hose to twist, or it will become loosened from the spout. Repeat with the second connection hose. Install the handles Swing C, Tango C, Limbo C only: Install the deco-rings on the handles All models: Hold the lever in the desired “off” position with one hand. With the other hand, turn the bell clockwise, so that it threads down over the valve stem. Install the pull rod Solaris E, Stratos E, Metro E, and Swing C only: The pull rod is curved. It should be installed with the curve as shown in the diagram. Tango C and Limbo C only: The pull rod is straight. Finish the installation Install the pop up drain. Install the supply lines (not included) according to the manufacturer’s directions. Turn on the water and check for leaks. Install the Pop Up Drain Remove the plunger assembly. Unscrew the drain outlet flange from the tee. Unscrew the tailpiece from the tee. Wrap the threads with Teflon tape and replace. Install the flexible sealing gasket to the flange. Sit it in the sink outlet. From under the sink, install the black mack gasket, white friction ring, and retainer nut to the flange. Do not tighten the nut against the bottom of the sink at this time. Thread the tee and tailpiece to the flange. The pivot must face the faucet. If necessary, turn the drain assembly. Tighten the retainer nut. Sit the plunger assembly in the drain. Install the horizontal rod through the pivot ball seals and into the tee so that the en...

Scarica la tua

Per scaricare, digitare 2 cifre :