|
Facilità d'uso
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interfer ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try and correct the interference by one or more of the following suggestions. Reorient or relocate the receiving antenna Increase the distance between the equipment and the receiver Connect the equipment to a different power outlet other than the one where receiver is connected Consult a certified television or radio technician Overview 2.5” form factor bracket CF Slot 1 CF Slot 2 Connector USB Port Note: The default setting for the RAID setting is BIG. The switch has 3 settings. You slide the switch from left to right to change RAID setting. SATA Power Connector SATA Data Switch Recommendations on using the AD2SAHDCF as a boot device The CF cards plug into the AD2SAHDCF can be configured as your boot drive. It is recommended that the CF cards be configured as a raid set first by connecting it as an external device. Steps: 1. 57xx SteelVine Manager Utility Installation Note: To monitor the status of your raid set, you need to install the Sil5744 SteelVine Manager. Install the utility from the CD that came with your package. a. Turn computer ON. Insert Host Controller Driver Disk into CDROM. b. The Addonics Technologies Driver Disk window pops up. c. Select Configuration Utilities. Sil5744 SteelVine Manager. To extract the utility select your operating system from the list. d. Extract the files into your system. e. Install SiI5744 Manager by clicking the 5700Package.msi. Follow the instructions. f. After software installation, run the SteelVine Manager. The 57xx SteelVine Manager Utility manual can found in the Driver Disk under User Guides or can be downloaded from ers_Guide_Rev_1.0.pdf 2. Insert the CF cards to the CF slots on the AD2SAHDCF. 3. RAID Configuration. Note: SATA Connection: The act of connecting and disconnecting the SATA power cable serves as the RAID Setting button to confirm RAID mode setting. USB Connection: The act of connecting and disconnecting the USB cable serves as the RAID Setting button to confirm RAID mode setting. a. Set the switch to the RAID configuration required. RAID Settings Switch b. SATA Connection: Connect the SATA data and power cable to the AD2SAHDCF to confirm RAID mode setting. USB Connection: Connect the USB cable to the AD2SAHDCF to confirm RAID mode setting. c. Check in the 57xx SteelVine Manager if the RAID configuration is correct. 4. Once you have confirmed you had...
Questo manuale è adatto anche per i modelli :Apparecchiature di rete - AD2SAHDCF (2.32 mb)
Apparecchiature di rete - AD2SAHDCF (2.32 mb)