valutazioni - 2, GPA: 4 ( )

Produttore : Black & Decker File Size : 2.12 mb File Nome : Lingua di insegnamento:

The tool is equipped with an approved three-conductor cord and three-prong grounding type plug to fit the proper grounding type receptacle. The green (or green and yellow) conductor in the cord is the grounding wire. Never connect the green (or green and yellow) wire to a live terminal. If your unit is for use on less than 150 volts, it has a plug like that shown in Figure A. If it is for use on 150 to 250 volts, it has a plug like that shown in Figure D. An adapter, Figures B and 0, is available for connecting Figure A plugs to two-prong receptacles. The green-colored rigid ear, lug, etc., must be connected to a permanent ground such as a properly grounded outlet box. No adapter is available for a plug as shown in Figure D. Adapter shown in Figures B & C is Not for Use in Canada. GROUNDED OUTLET BOX « mugis MUST IF MUMS ■ A. -j§p; WHET BOX .ADAPTER MEANS OUTLET BOX * Wilis LiilESI If mu © © B. P. Fig. I We recommend that you NEVER disassemble the tool or try to do any rewiring in the electrical system. Any repairs should be performed only by B&D Service Centers or other qualified service organizations. Should you be determined to make a repair yourself, remember that the green colored wire is the “grounding” wire. Never connect this green wire to a “live'1 terminal. If you replace the plug on the power cord, be sure to connect the green wire only to the grounding (longest) prong on a 3-prong plug. SWITCH To start tool, depress trigger; to stop, release trigger. To lock trigger in "ON" position for continuous operation, depress trigger, push in locking button, and release trigger. To release locking mechanism and turn off tool, depress trigger and release. ATTACHING DISCS 1. Place Backing Pad and sanding disc on spindle of tool. 2. Screw Clamp Washer PARTIALLY on the spindle. 3. With one hand, depress the spindle lock button and hold the button down. Grasp the pads and sanding disc with the other hand and turn by hand to tighten the entire assembly (fig. 1). To remove pads and discs: depress spindle lock button; grasep the pads and disc; and turn pad and disc assembly in opposite direction. OPERATION Grasp the control handles firmly and operate the tool freely without forced effort or unnecessary pressure. For maximum efficiency, the tool must be positioned so that the sanding disc is at the proper angle to the work. Fig. 2 (marked “RIGHT”) illustrates how the tool is tipped slightly in order to let the maximum amount of abrasive contact the work without affecting the smoothness of the sanding action. Fig. 3 and Fig. 4 (marked “WRONG”) show incorrect positions which allow either too little or too much abrasive contact. If only the outer edge of the sanding disc is used (as in Fig. 3), a rough cut surface will result. If the sanding disc is pressed flat against the work (as in Fig. 4), the cutting action will be irregular and bumpy, and the tool will be difficult to control. CLEANING Blowing dust and grit out of the ...

Scarica la tua

Per scaricare, digitare 2 cifre :