valutazioni - 4, GPA: 4.5 ( )

Produttore : Milwaukee File Size : 283.09 kb File Nome : Lingua di insegnamento:

For simplest installation, rest the tool on its pad with the power cord on your left side. Slide the half of the shroud without the dust bag over the base of the sander on the side opposite you. Slide the half of the shroud with the dust bag over the base of the sander on the side nearest you and squeeze both halves together until they lock at both ends. To remove the dust pick-up, unplug the tool and rest the sander on its pad with the power cord on your left side. Release the tabs at each end and slide each shroud half off. To empty the dust bag, remove the shroud from the tool, open the zip-pered edge of the bag and gently shake the dust into a container. DO NOT REMOVE THE DUST BAG FROM THE SHROUD. MAINTENANCE All servicing other than what is recommended in this instruction manual must be performed by a MILWAUKEE Service Center or Authorized Service Station. LUBRICATION The MILWAUKEE Orbital Sander is equipped with grease sealed bearings and requires no further lubrication. BRUSHES AND COMMUTATOR To inspect the brushes, unplug the tool and unscrew the brush retainer caps located in the motor housing. Remove the retaining springs and the brushes. Replace the brushes when they are worn down to 1/4". Always replace the brushes in sets. While the brushes are removed, the commutator can be inspected by looking through the brush tube as well as through the side air intake vents. If the commutator is rough or dirty, send the complete tool to a MILWAUKEE Service Center or Authorized Service Station for undercutting and dressing of the commutator. When inserting brushes, the curved surface of the brush carbons should be positioned so they seat properly on the surface of the commutator. Replace the springs and the brush retainer caps being careful not to overtorque them. ACCESSORIES DUST PICK-UP KIT (For Sander No. 6014) STEEL CARRYING CASE Catalog No. 48-09-0300 Catalog No. 48-55-0740 (See page 6 for installation instructions) USE ONLY IDENTICAL REPLACEMENT PARTS Parts List Available On Request. When ordering, include Catalog No. and Serial No. of Tool. Write: MILWAUKEE ELECTRIC TOOL CORP. SERVICE DEPT. 13135 W. Lisbon Rd. Brookfield, Wl. 53005 HEAVY DUTY TOOLS FOR CONTRACTORS AND INDUSTRY Every MILWAUKEE Tool is thoroughly inspected and tested before leaving the factory. Should any trouble develop, return the complete tool prepaid to the Factory, Branch or nearest Authorized Service Station. If inspection shows the trouble is caused by defective workmanship or material, all repairs will be made without charge and the tool will be returned transportation prepaid. This warranty does not apply where: (1) repairs or attempted repairs have been made by persons other than Factory, Branch or Authorized Service Station personnel; (2) repairs are required because of normal wear; (3) the tool has been misused or involved in an accident; (4) misuse is evident such as caused by overloading the tool beyond its rated capacity; (5) the tool has been used after partial failure or (6) the tool has been used with an improper accessory. No other warranty written or verbal, is authorized. MILWAUKEE ELECTRIC TOOL CORPORATION 13135 W. LISBON ROAD BROOKFIELD, WISCONSIN 53005 58-12-2331 0182 Litho in U.S.A....

Scarica la tua

Per scaricare, digitare 2 cifre :