valutazioni - 3, GPA: 4
(
)
)
|
Facilità d'uso
– Shredder must be operated in upright position only. – Set up paper shredder so that the ventilation slots are unobstructed. To ensure sufficient ventilation of the shredder a minimum distance of 4" (10 cm) to the wall or to the furniture must be maintained. 7. Operation Read operating instructions before operating the shredder. Insert plug in power outlet. To avoid motor overload, the 190 and 200 model paper shredders may cut out automatically after approx. 20 minutes of continuous operation. Switching equipment ON (190 & 200 only) 1 – Press rocker switch to pos. (1) • Controller switch locks in "on" position. • Equipment is ready for operation (standby). – Feed paper • The shredding process is started by automatic start stop control in the paper feed opening. Insert paper and shredding begins automatically. • When the shredding is complete, the cutting system automatically stops after approx. 3 seconds. Switching equipment OFF (190 & 200 only) – Press rocker switch to pos. (3) • switch resets to center position and 3 stops the cutting system. Switching equipment ON (220 series only) 1 – Press rocker switch to pos. (1) • Switch locks in "on" position. • Equipment is ready for operation (standby). • Green LED lights. – Feed paper • The shredding process is started by photo–cells in the paper feed opening. Insert paper and shredding begins automatically. • When the shredding is complete, the cutting system automatically stops after approx. 3 seconds. Switching equipment OFF (220 series only) – Press rocker switch to pos. (3) 3 • switch resets to center position and the machine is turned off. 1.294.999.110 Edition 09/98 USA 200 220 Paper shredder 220 CC 8. Checklist for Inoperative Machine If the equipment does not work properly, please check the following points first: – Is the plug inserted ? – Is the switch turned on ? – Is waste container pushed in properly ? – Is waste container full ? Empty container – Is there a paper jam in the shredder ? See Malfunctions – Is the motor overheated ? Switch machine off and allow motor to cool down for approximately 15–20 min. If none of the above applies and the equipment still does not run, please contact the appropriate customer service department. 9. Malfunctions Paper jam • Press rocker switch to center position 2 (2) to stop the cutting system. • Press and hold down rocker switch in 3 pos. (3) to reverse the cutting system and back out jammed material (paper is pushed out) Caution! 1 Do notpress rocker switch alternately 3 forwards/backwards in pos. (1 and 3) • Remove excess paper. 1 • Return switch to pos. (1) and continue shredding in smaller quantities so as not to jam the machine further. Door contact interrupted Red LED lights (220 series only). No LED on 190 & 200 models. – Paper shredder switches off automatically. Press rocker switch to center (2) 2 position. • Check whether cut material container is properly pushed into bottom frame. 1 • Return switch to "on" position (1) and continue shredding. Cut material container full Red LED lights (220 series only). No LED on 190 & 200 models. – Paper shredder switches off automatically. • Press rocker switch to center (2) 2 position. • Empty cut mate...
Questo manuale è adatto anche per i modelli :Trituratori - 190 (80.93 kb)
Trituratori - 200 (80.93 kb)
Trituratori - 220CC (80.93 kb)