valutazioni - 3, GPA: 3.7 ( )

Produttore : Craftsman File Size : 3.31 mb File Nome : Lingua di insegnamento:

4. One at a time, remove the belts from the lower pulley and upper pulley and fan assembly. 5. Install the new belts on the pulleys and reinstall the idler arm spring. HEADLIGHT REPLACEMENT 1. Open the hood. 2. Remove the forward heat shield. 3. Remove the light bulb socket from the bezel by twisting it counterclockwise and pulling it out. 4. Use a rag or gloves to remove and replace the light bulb with an identical halogen bulb. DO NOT TOUCH THE BULB WITH YOUR BARE HANDS. 5. Reinstall the socket into the bezel. TAILLIGHT & DASHLIGHT REPLACEMENT 1. Twist the socket counterclockwise and pull out to remove it from the taillight or dashboard display. 2. Remove and replace the old bulb with a new identical bulb. 3. Reinstall the socket into the taillight bezel or dashboard display. Figure 41. PTO Belt Removal A. Idler Arm Spring Figure 42. Headlight Replacement Figure 43. Taillight Replacement To avoid damaging belts, DO NOT PRY BELTS OVER PULLEYS. Troubleshooting, Adjustment & Service A Troubleshooting, Adjustment & Service MOWER ADJUSTMENTS WARNING Roller Bracket Adjustment (60” Mower Only) The anti-scalping rollers (A, Figure 44) can be adjusted for different cutting heights by positioning roller brackets on the mower baffle (B). 1. Remove bolts, lockwashers and nuts securing roller bracket to baffle. 2. If you typically cut using the lower half of the mower cutting height range, the roller brackets should be positioned in the upper set of holes. 3. Use the lower set of holes if mowing is usually done in the upper half of the cutting height range, or if scalping occurs at lower cutting heights due to uneven terrain. Before checking mower, shut off PTO and engine. Allow all moving parts to stop. Remove ignition key, then disconnect the spark plug wires and fasten them away from the spark plugs. A B Figure 44. Anti-Scalping Rollers A. Rollers B. Mower Baffle Pulley Stop Adjustment (48” Mower Only) The pulley stop (A, Figure 45) prevents the idler pulley from contacting the idler arm tension spring (B) when the deck is engaged. 1. Remove the mower deck. See MOWER DECK REMOVAL & INSTALLATION. 2. Remove the left side cover. 3. Loosen the idler pulley bolt and orient the pulley stop (A) as shown in Figure 45. BA Figure 45. Pulley Stop Position A. Pulley Stop B. Idler Arm Tension Spring Gauge Wheel Adjustment (54” Mower Only) The mower gauge wheels can be placed in two positions depending on the height of cut. When using higher cutting heights, set the wheels in the lower position. When using lower cutting heights, set the wheels in the upper position. To adjust: 1. Remove the hair pin clip (A, B, Figure 46). 2. For upper position, install the pin (A) through the spindle above the bracket (C). For the lower position, push down on the top of the spindle, and install the hair pin clip (B) below the top of the bracket (C). A B C Figure 46. Gauge Wheel Adjustment A. Hair Pin (U...

Scarica la tua

Per scaricare, digitare 2 cifre :