valutazioni - 4, GPA: 4.5 ( )

Produttore : Craftsman File Size : 1.74 mb File Nome : Lingua di insegnamento:

2. Pull the Auger Control back against the handle to engage the auger. NOTE: The snow thrower will be pulled forward by the auger when the auger contacts the ground or with the snow to be thrown. 3. Begin snow removal by clearing a path down the center of walk or driveway, then gradually widen path, throwing snow off to both sides. 4. Release the Auger Control to stop both the auger and the forward motion of the snowthrower. WARNING Do not use snow thrower on surfaces above ground level, such as the roof of a building. SNOWTHROWING TIPS Varying snow conditions will affect performance of snow thrower. The snow thrower should be allowed to move into the snow at it's own pace. Wet, heavy snow — When clearing wet, heavy snow, the forward movement of the snowthrower may have to be slowed by pushing down on handle while allowing engine to operate at full throttle. Do not operate on gravel or crushed rock surfaces. Avoid picking up this type of material with auger since damage to unit could result and particles can be discharged with considerable force that could cause serious injury. Always be alert to hidden hazards that might be struck by the auger. Should a foreign object be struck by the auger, immediately stop the engine and inspect machine for any damage. Repair damage before continuing operation. AFTER EACH USE Allow snow thrower to run a few minutes after clearing snow to reduce the likelihood of parts freezing while machine is not is use. If you will be storing the unit for the season, see the STORAGE section for instructions on properly preparing the unit for long-term storage. Controls & Operation OFF-SEASON STORAGE Before you store your snowthrower for the off-season, read the Maintenance and Storage instructions in the Safety Rules section and take the following precautions: NOTE: Gasoline, if permitted to stand unused for extended periods (30 days or longer), may develop gummy deposits which can adversely affect the engine carburetor and cause engine malfunction. To avoid this condition, add Simplicity Gasoline Stabilizer to the fuel tank, or drain all fuel from the system before placing unit in storage. 1. Prepare your snowthrower engine for storage as instructed in the Engine Owner’s Manual. 2. Lubricate the snowthrower as described in the LUBRICATION section of this manual. 3. Clean the snowthrower thoroughly. Coat exposed bare metal parts with a quality paint (available from you dealer) or a light film of grease, oil or automotive wax. 4. Store snowthrower in the wheels down, operating position. Note: If the unit is stored in any other position, fluids may leak. 5. Store the unit in a protected area and cover. STARTING AFTER STORAGE 1. Remove the spark plug and wipe dry. Then reinstall plug. 2. Fill fuel tank with fresh gasoline (unless a fuel stabilizer was used). 3. Check to be sure engine fins are clean and air flow is unobstructed. 4. Start the engine outdoors. Warm up engine by running at SLOW speed for a a few minutes before run...

Scarica la tua

Per scaricare, digitare 2 cifre :