valutazioni - 2, GPA: 3.5
(
)
)
|
Facilità d'uso
5.1 Overview Before operating the Campus Pager, be sure that you understand the following information concerning the paging system’s capabilities. The Campus Pager covers a maximum range of up to two miles using the supplied center-loaded antenna. This distance is based on average conditions over a line-of-sight path. This range may be less, depending on surrounding conditions. The Campus Pager sends a number (from 0-9) to one or all of the pagers. The pagers in turn beep and display the numbered message. Each pager has a label where you can write down the message you’ve established for each number. We recommend that you use a pencil, so the number can be easily changed at a later date. Each pager has its own pager code, which allows the Campus Pager to send a message to a single pager, or to ALL of your system’s pagers using the TRANSMIT ALL feature. You can record each of the pager codes, and their corresponding users on the card located under the Campus Pager. (The card is inside the bottom of the unit and must be pulled out from the front.) You can also write down the messages represented by each message code. Again, we recommend that you use a pencil, so the number can be easily changed at a later date. 5.2 Storing the System Code Before you can use the Campus Pager, you must designate a system code. The system code ensures proper signaling between the Campus Pager and the pager. To enter and store a system code, follow these steps: 1. Turn the Campus Pager power on. 20 CAMPUS PAGER 2. Turn the Campus Pager over and locate the system code button, which is inside the hole labeled SYSTEM CODE. Insert a pointed object such as a straightened paper clip and press the button (see Figure 5-5). The TRANSMIT display will show the previous system code for about one second, then shows ___. Figure 5-1. The Campus Pager system code button. 3. Enter a three-digit system code. After about one second, the display shows ___, and the system code is stored. 4. If you enter a wrong code, reset it by pressing A/C, CANCEL, or the system code button. Then repeat Steps 2 and 3 to store the system code again. NOTE If your application requires more than 100 system pagers, you can use multiple Campus Pager systems. If using more than one Campus Pager, each system should have a unique system code. 21 CAMPUS PAGER 5.3 Storing the Pager Code Before you can use the Tone Pager or Vibrating/Tone Pager, you must designate a pager code for each of the pagers. NOTE You must reset all pager codes when you enter a new system code. To enter and save a pager code, follow these steps: 1. Turn the pager OFF. 2. Press and hold the ON/OFF switch, then slide it to the ON position (see ON OFF Figure 5-2. Pager ON/OFF Switch. 22 CAMPUS PAGER 3. Make sure that the Campus Pager is turned ON, then enter a two-digit pager code (00-99) and then 0. 4. Press the TRANSMIT button on the Campus Pager, and the unit will transmit the pager code to the pager. The pager will beep four times, and flash...
Questo manuale è adatto anche per i modelli :Cellulari - FX800A (116.8 kb)
Cellulari - FX800AE (116.8 kb)
Cellulari - FX801A (116.8 kb)
Cellulari - FX810A (116.8 kb)