valutazioni - 2, GPA: 5
(
)
)
|
Facilità d'uso
The TEXT Button 17 6 SETTING FROM THE MAIN MENU 17 6 TV channels and radio channels 18 7 TV Guide and Radio Guide 18 Edit Channels 18 7 Rearrange List 19 Rename List 19 7 Add channels 19 8 Lock channels 19 8 Rearrange channels 20 8 9 Remove channelsUSER PREFERENCES 20 20 10 Parental control 20 11 Language settings 21 System settings 21 11 12 12 On/Off Timer settingGAMEINSTALLATION SUBMENUS 22 22 23 12 Antenna Satellite configuration 23 13 Automatic channel search 23 14 Manual channel search 23 14 Advanced channel search 23 14 Reinstall 24 15 15 15 15 16 16 System InformationCONDITIONAL ACCESS GLOSSARY OF TERMS PROBLEM SOLVINGTECHNICAL SPECIFICATION MENUS SCREEN STRUCTURE 24 24 25 26 27 28 Nokia Home Communications operates a policy of continuous development. Therefore we reserve the right to make changes and improvements to any of the products described in this manual without any prior notice. The EMC Directive 89/336/EEC is applied to this product. DiSEqC™ is a trademark of EUTELSAT Nokia is a registered trademark of Nokia Corporation. Copyright © 2000. Nokia Home Communications. All rights reserved. GB 3 FOR YOUR SAFETY FOR YOUR SAFETY Keep a clear space around the Mediamaster to allow for sufficient ventilation. Do not cover the Mediamaster or place it on a unit that emits heat. !• Use a soft cloth and a mild solution of dish washing liquid to clean the casing. !• Never allow liquids, spray or other materials to come into contact with the inside of the Mediamaster. !• Service should be carried out only at a Nokia authorized service center. !• Do not connect or modify cables when the Mediamaster is plugged in. !• Do not remove the cover. !• Do not allow the unit to be exposed to hot, cold or humid conditions. !• Please note that the only way to isolate the Mediamaster completely from the 230 V mains supply is to unplug the mains lead! Rear panel LNB input RS232 TV SCART VIDEO OUTPUT TV AERIAL AC INLET Satellite dish For a PC. For the audio Composite video For a terrestrial 230 V AC input /video input of the signal output for a (conventional) 50 Hz (F-connector). TV set. TV set. TV aerial. LNB output MODEM VCR SCART AUDIO L R TV/VCR Satellite signal (IF) output For connection For connection to a Stereo outputs for For an RF-Cable with loop through. For to an external VCR or an analogue connection to a HiFi to the aerial connection to the other MODEM satellite receiver. system. input of the TV satellite receiver if needed. or VCR. GB 4 Front panel Display Slot Shows channel number, remote control For a two CA signal and time in standby mode. Module With a At start up, it displays the model number. Smartcard Power Up/Down To turn the receiver Select channel number, on/off (standby). up/down. INSTALLATION OF THE MEDIAMASTER The box for your Mediamaster should contain the following items: Mediamaster 9650S includes Owner’s Remote Controller Power cable SCART Cable Manual and Batteries About the SCART sockets !• The rear panel of the Mediamaster is equipped with 2 SCART sockets. When you connect other products to any of these sockets, always use fully featured SCART cables (as supplied). There are “less well specified” SCART cables on the market and picture quality could be reduced if you use them. !• SCART cables are also necessary to get stereo sound from a stereo TV and video recorder. GB 5 8 mm 3 mm 15 mm 8 mm 3 mm 15 mm Connecting the Mediamaster to the satellite dish Installing the satellite dish !• Your satellite dish should be installed with a cable for you to connect to the Mediamaster. If you do not have this cable you will need to buy one from a dealer (tell the dealer you need a coaxial cable and F-connectors). !• Connect the cable from the satellite dish to the socket marked ”LNB IN” on the back of the Mediamaster. If you need to fit the F-connectors onto the cable Prepare each end of the cable as shown in the diagram. You will need to fold back the outer braid (as shown). !• Slide the F-connector onto the cable, and then turn it clockwise F-connector until it grips the braid. !• Ensure that 3 mm of the core is protruding from the end of the connector. Connecting the Mediamaster to a TV set There are many different types of TV/VCR and other equipment that you can connect to the Mediamaster. In this manual you will see some of the most common ways to connect your equipment. If you use RF cables you will have to tune your TV and VCR to the Mediamaster output channel. If you have problems with your connections and need help, contact your dealer or Service Provide. !• Connect the SCART cable between the main SCART socket on the TV and the TV SCART socket on the Mediamaster. !• Connect an RF cable from the TV/VCR output on the Mediamaster to the RF input socket on the TV. !• Connect the TV aerial to the TV AERIAL input socket on the Mediamaster. GB 6 Connecting to a TV and a Video recorder Refer to your video recorder manual for full instructions. !• Connect one SCART cable between the main SCART socket...