valutazioni - 1, GPA: 3
(
)
)
|
Facilità d'uso
The black wire should have a #6 ring terminal crimped on (not supplied) and connected to chassis ground. Caution while Installing the Antenna • Install the antenna onto the inside glass so it does not fall down while driving. • Install on a clean glass surface. Moisture can cause the antenna to fall down. • Low temperature decreases the adhesion. Therefore, turn on the heater if temperature is below 68 degree Fahrenheit. • Do not touch the sticky part of the tape. • Keep the distance between the side of window and antenna element to a minimum of 1 inch. Touching the windows can affect the transmission. • Do not run the antenna cables next to power or speaker leads or noise problems can occur. 1 Thoroughly clean the glass area with a clean cloth and glass cleaner. i Be certain temperature ofthe glass is above 68 degrees Fahrenheit. 1 Remove the protective tape and mount the booster section. ' Remove the protective tape and mount the antenna wire sections. i Make certain that antennas are securely installed with antenna holders provided. ' Stick the protective seal on the outside ofthe window to hide the sticky part of the booster amp. Antenna Performance • A car with a rear defroster or heating refract film can deflect the signal which causes poor reception. Please check the type of glass and film before installing the product. • Install this product on the inside of the car. Therefore, in some cases, image of television can be affected. • Weak signals can be the cause ofpoor image or sound. • Heater, fan and other functions of the car can affect the TV reception. • Tunnels or buildings can deflect the signals. TV ANTENNA • POWER: DC 12-14.4V • AUX TYPE: MINUS • MAX POWER AMP: 50mA • OUTPUT TERMINAL: 3.5 MINI PLUG *2(1PCS) • LENGTH OF THE ANTENNA CABLE: 16.54 INCHES • SIZE OF THE BOOSTERAMP SECTION: 2.56*2.13INCHES • WEIGHT: 470G(INCLUDING CABLE)(1PCS) ACCESSORIES • POWER CORD HOLDER: 6 • ANTENNA HOLDER: 4 • BODY COVER: 2 • INSTRUCTION BOOK: 1 • CIGARETTE LIGHT PLUG:1 Note : Parts or design are subject to change without notice....