valutazioni - 3, GPA: 4
(
)
)
|
Facilità d'uso
Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder. To aid cleaning, the top part of the additive compartment should be removed. Cleaning the drawer recess Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme without any clothes in the drum. Cleaning the pump The pump should be inspected if • the machine does not empty and/or spin • the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump. 126.2943.07…AWF5120-8120W.qxd 23/10/08 15:54 Pagina 48 126.2943.07…AWF5120-8120W.qxd 23/10/08 15:54 Pagina 48 48 care and cleaning Proceed as follows: • Disconnect the appliance. • If necessary wait until the water has cooled down. • Open the pump door. • Place a containfer close to the pump to collect any spillage. • When no more water comes out, unscrew the pump cover and remove it. Always keep a rag nearby to dry up spillage of water when removing the cover. • Remove any objects from the pump impeller by rotating it. • Screw the pump cover fully in. • Close the pump door. Warning! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it. Cleaning the water inlet filter If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged. It is therefore a good idea to clean it from time to time. Turn off the water tap. Unscrew the water inlet hose. Clean the filter using a hard bristle brush. Tighten up the inlet hose. The dangers of freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken. • Turn off the water tap. • Unscrew the inlet hose. • Place the end of the inlet hose in a bowl placed on the floor and let water drain out. • Screw the water inlet hose back on. • When you intend to start the machine up again, make sure that the room temperature is above 0°C. 126.2943.07…AWF5120-8120W.qxd 23/10/08 15:54 Pagina 49 126.2943.07…AWF5120-8120W.qxd 23/10/08 15:54 Pagina 49 care and cleaning 49 Important! Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run the drain programme. This will activate the ECO VALVE device avoiding that part of the detergent remains unused at next washing. Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: • pull out the plug from the power socket; • close the water tap; • if necessary, wait until the water has cooled down; • open the pump door; • clean the pump if necessary as previously described; • screw the pump cover again and close the door. 126.2943.07…AWF5120-8120W.qxd 23/10/08 15:54 Pagina 50 126.2943.07…AWF5120-8120W.qxd 23/10/08 15:54 Pagina 50 50 something not working Something not working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red Start/Pause pilot light flashes to indicate that the machine is not working. Once the problem has been eliminated, press the Start/Pause button to restart the programme. If after all checks, the problem persists, contact your local Service Centre. Malfunction Possible cause Solution The washing machine does not start: . The door has not been closed. (Red Start/Pause pilot light flashes). . The plug is not properly inserted in the power socket. . There is no power at the socket . The main fuse has blown. . The selector dial is not correctly positioned and the Start/Pause button has not been depressed. . The delay start has been selected. . Close firmly the door. . Insert the plug into the power socket. . Please check it. . Replace the fuse. . Please turn the selector dial and press the Start/Pause button again. . If the laundry are to be washed immediately, cancel the delay start. The machine does not fill: . The water tap is closed. . Open the water tap. (Red Start/Pause pilot light flashes) . The inlet hose is squashed . Check the inlet hose or kinked. (Red connection. Start/Pause pilot light flashes) . The filter in the inlet hose is . Clean the water inlet hose blocked. (Red Start/Pause filter. pilot light flashes) . The door is not properly closed. (Red Start/Pause . Close firmly the door. pilot light flashes) The machine fills then . The end of the drain hose is . Refer to relevant paragraph empties immed...
Questo manuale è adatto anche per i modelli :Lavatrici - AWF 8120 W (5.9 mb)