valutazioni - 4, GPA: 4
(
)
)
|
Facilità d'uso
Manufacturer shall not be held responsible for damages arising from processes carried out by unauthorised persons. • Connect the product to a grounded outlet protected by a fuse of suitable capacity as stated in the technical specifications table. • Operate your product at temperatures between +5°C and +35°C. • Do not use electrical devices in the product. • Do not connect the air exit of the product to the chimney holes which are used for the exhaust fumes of the devices operating with gas or other types of fuel. • You must provide enough ventilation in order to prevent gases exiting from devices operating with other types of fuels including the naked flame from accumulating in the room due to the back fire effect. • Always clean the lint filter before or after each loading. • Never operate your dryer without the lint filter installed. • Do not allow fibre, dust and dirt accumulation around the exhaust exit and at adjacent areas. • Power cable plug must be within easy reach after installation. • Do not use extension cords, multi- plugs or adaptors to connect the dryer to power supply in order to decrease the risk of electric shock. • Do not make any changes on the plug supplied with the product. If it is not compatible with the socket, have a qualified electrician change the socket with a suitable one. • Items cleaned or washed with gasoil/ fuel oil, dry-laundry solvents and other combustible or explosive materials as well as the items that are contaminated or spotted with such materials should not be dried in the product since they emit flammable or explosive vapor. • Do not dry items cleaned with industrial chemicals in the dryer. • Do not dry unwashed items in the dryer. • Items soiled with cooking oils, acetone, alcohol, fuel oil, kerosene, stain remover, turpentine, paraffin and paraffin removers must be washed in hot water with plenty of detergent before being dried in the dryer. • Garments or pillows bolstered with rubber foam (latex foam), shower bonnets, water resistant textiles, materials with rubber reinforcement and rubber foam pads should not be dried in the dryer. • Do not use fabric softeners and anti-static products unless they are recommended by the manufacturers of the fabric softener or the product. • This product must be earthed. Grounding installation decreases the risk of electric shock by opening a path with low resistance for the electricity flow in case of a malfunction or failure. Power cable of this product is equipped with a conductor and a grounding plug that allows for grounding the product. This plug must be installed appropriately and inserted into a socket which is grounded in accordance with the local laws and regulations. • Do not install the product behind a door with a lock, sliding door or a door that has a hinge against the hinge of the dryer. • Do not install or leave this product in places where it will be exposed to outdoor conditions. • Do not tamper with the controls. • Do not perform any repair or part replacing procedures on the product even if you know or have the ability to perform unless it is clearly suggested in the operating instructions or the published service manual. • Inside and exhaust duct of the product must be cleaned by the qualified service personnel periodically. • Wrong connection of grounding conductor of the product can cause electric shock. If you have any suspect about the grounding connection, have it checked by a qualified electrician, service representative or service personnel. • Do not reach into the machine when the drum is spinning. • Unplug the machine when it is not in use. • Never wash down the appliance with water! There is the risk of electric shock! Always disconnect by unplugging from the mains before cleaning. • Never touch the plug with wet hands. Never unplug by pulling on the cable, always pull out by grabbing the plug only. Do not operate the machine if the power cable or plug is damaged! • Never attempt to repair the machine yourself, otherwise, you will be putting your life and others’ lives in danger. • For malfunctions that cannot be solved by following the information given in the safety instructions: Turn off the machine and contact an authorised service agent. • Do not stop the dryer before the drying cycle comes to an end unless you will remove all laundry from the dryer fast in order to lay them and dissipate the heat. • Remove the door of the drying compartment before decommissioning or disposing of the product. • The final step of the drying cycle (cool- down cycle) occurs without applying heat to ensure that the items are left at a temperature that will not damage them. • Fabric softeners or similar products should be used as specified by the fabric softener instructions. • Underwear that contains metal reinforcements should not be placed in a dryer. Damage to the dryer can result if metal reinforcements come loose during drying. • Check all garments for forgotten lighters, coins, metal pieces, needles, etc. ...