valutazioni - 2, GPA: 3.5 ( )

Produttore : Haier File Size : 1.57 mb File Nome : Lingua di insegnamento:

4. Press “Timed Dry” button to set the required drying time; Press “Temp” button to set the required drying temperature. In “Touch Up” cycle only a 20 minutes Timed Dry can be selected. Temp in “Touch Up” cycle is High Medium Low. Temp in “Gentle Dry” cycle is low only. 5. When starting the machine close the door first, then press the “Start/Pause” button. If a pause is needed during drying, press this button. Pressing again will resume operation. 6. Regardless of the dryer status (drying, pause or cool down), by turning the dial to “Off” position, the “Off” indicator light will flash for 5 seconds and then go into stand by mode. When the machine is running, turn the dial in any direction, the cycle will automatically turn “Off”. Note: To change the cycle press “Start/Pause”, turn dial to new selection and press “Start/Pause” again. 22 English Other Features Your dryer also has the following features for your convenience: Lint Filter: • All dryers come with a lint filter that needs to be cleaned before or after every use (read “Care and Cleaning Guide” Section). Leveling Legs: • Your dryer has four leveling legs which are located in the front and rear corners of your dryer. After installing your dryer in its final position, you can level your dryer. • Leveling legs can be adjusted by turning them clockwise to raise your dryer or by turning them counterclockwise to lower your dryer. End of Cycle Signal: • At the end of the dry cycle an audible signal will beep to alert you that the dryer has completed drying the load. Wrinkle Saver: • At the end of the dry cycle the dryer will automatically go into the wrinkle saver mode. Here the dryer tub will tumble periodically for 1 hour after the dry cycle is completed. To stop simply open the door and remove the clothes. 23 English NORMAL OPERATING SOUNDS The following sounds are normal during the operation of the dryer. • Tumbling sound: this is normal as the heavy wet clothes in the dryer are continuously being tossed around. • Air rushing noise: this happens as the dryer drum spins and the air is rushing through the dryer drum. Tips • For best drying results, clean the lint filter before or after every use. • Do not overload the dryer. The appropriate load is 1/3 to 1/2 of the drum volume. • Balance the dryer load evenly throughout the dryer for the best result. • Drying time depends on many variables: load size, type of fabric and moisture in it, heat and moisture in the room, electric voltage, length of the exhaust duct, etc. • To eliminate guessing and to conserve energy, it is recommend for certain clothes to dry on an auto-drying setting. • Always follow the fabric care instructions supplied by the garment manufacturer. CARE AND CLEANING GUIDE • Lint filter needs to be cleaned before or after each use for your unit to operate at optimum efficiency. The filter can be removed by pulling on the tabs located on the inside of the dryer door. The filter may be washed or vacuumed. Remove the excess water f...

Scarica la tua

Per scaricare, digitare 2 cifre :