valutazioni - 2, GPA: 4
(
)
)
|
Facilità d'uso
It is not a substitute for responsible and proper adult supervision and should not be used as such. Make sure the Baby unit and adapter cable are always out of reach of the baby, at least 1 metre away. Never place the Baby unit inside the baby’s bed or playpen! The antennas on the Parent and Baby units are fixed; do not try to extend them. Never cover the Baby unit (with a towel, blanket, etc. ) 4 IFUSC369ENbk.p65 4 TECHNICAL SPECIFICATIONS Power supply – Battery pack; rechargeable NiMH for small Parent Unit (included); – Optional batteries 4 x 1.5V; AA alkaline for Baby Unit and big – AC power adapter 230V AC, 50 Hz (three Only use the AC power adapter included or has the following specification: 9 Volt DC / 200mA. Operating range – up to 200 metres in ideal conditions (This means that the in between. Walls, ceilings, large objects and even glass affect the operating range. The more obstacles in between, the shorter the operating range) – 10°C to 40°C Continuous transmission – the baby unit now monitors sounds continually as long as it is switched on. you can be confident of hearing any sounds your baby makes at all times. Transmission frequencies Channel A Channel B SBC SC369/05 (IRE, UK): 49.890 MHz 49.830 MHz SBC SC369/05 R&TTE Directive 1999/5/EC 0682 BE DK GR ES FR IRE . IT LU NL AT PT FI SE UK . NO DE CH . Helpline IRELAND UK Phone : 01- 7640292 Phone : 0208-665-6350 9 14/10/2002, 11:29 PROBLEM SOLVING Problem Possible Cause Solution Power light does not light Unit is not turned on. Turn Volume control/Off switch (Parent unit). clockwise (B-4, C-4). Batteries are low. Recharge batteries. Power light does not light (Baby unit). Unit is not turned on. AC adapter is not plugged in or Batteries are exhausted. Push the Power switch (A-4) to switch on the unit. Plug in AC adapter or replace batteries. AC adapter plugged into an outlet that is not working. If the power socket has a switch, turn it on. High pitched noise. Units are too close together. Volume too high. Move Parent unit away from Baby unit. Turn volume control on Parent unit counter-clockwise. Parent unit batteries do not Battery life is at an end. Replace rechargeable battery charge. pack. No sound. Volume control on Parent unit is set too low. Turn volume control/Off switch clockwise (B-4, C-4). Units are out of range. Move Parent unit closer to Baby unit. Power light blinking. Batteries are low or empty. Parent unit:- recharge batteries. Baby unit:- replace batteries or connect to mains power. Interference or poor Mobile or cordless phones too Move the phones away from the reception. close to the baby monitor can units. cause interference. Receiving signals from a Both systems are using the same Switch channels. different baby monitor. frequencies System check light flashing/ Units are out of range or there is Move parent units closer to baby system check alarm activated interference from another FM unit to restore the link. Remove source the other FM source. 8 IFUSC369ENbk.p65 5 GETTING THE UNITS READY FOR USE Baby unit Connect the AC power adapter (power supply socket (A-5) of the Baby If you want to use batteries, remove the Insert four 1.5V, AA batteries (not included; we recommend non-chargeable Philips Alkaline batteries), noting the + and - configuration inside the battery compartment. The Baby unit operates cordlessly for up to 30 hours POWER light (A-2) flashes when battery power is low. If this happens install Note: To switch off the Baby unit completely push the POWER button (A-4) . Small Parent unit The small Parent unit uses a rechargeable battery pack. This is already installed, but first it must be charged for at least 14 hours as follows before using the unit outside the charging base: • Connect the AC power adapter (B-11) to an AC mains socket, and then connect power supply socket (B-10) of the charging base (B-6). • Place the small Parent unit inside the charging base. The red charging light (B-13) lights. The small Parent unit can be operated now but you should leave it in the charging base until the batteries are fully charged (at least 14 hours). When the batteries are fully charged, take the small Parent unit out of the charging base and use cordlessly for up to 12 hours. When the red POWER light (B-2) on the small Parent unit flashes, the battery power is low. Place the small Parent unit inside the charging base to recharge the batteries. Big Parent unit Connect the AC power adapter (...
Questo manuale è adatto anche per i modelli :essiccatori - SC369 (3.38 mb)
essiccatori - SBC SC369 (3.38 mb)