Important ! The dryer should be located where a minimum amount of exhaust ducting will be necessary. The dryer must be installed with adequate clearance for air openings into the combustion chamber. Caution ! This dryer produces combustible lint and must be exhausted to the outdoors. Every 6 months, inspect the exhaust ducting and remove any lint buildup. Important The dryer must be installed in a location/ ! environment, which the ambient temperature remains between 40° F (4.44° C) and 130° F (

(If this tumbler changes ownership, be sure this manual accompanies the tumbler.) Installation/ Part No. M414545 September 2002 TABLE OF CONTENTS SECTION I Safety Important Safety Instructions. . . . . . . . . . . . . . . . . . 5 SECTION II Introduction Information for Handy Reference . . . . . . . . . . . . . . 7 Parts Ordering Information . . . . . . . . . . . . . . . . . . . 8 Nameplate Location . . . . . . . . . . . . . . . . . . . . . . . . . 8 Roughing-In Dimensions and Specifications Cabi

Installation Instructions Gas & Electric Dryer Instructions d’installation Sécheuse à gaz ou électrique P/N 134940500A (0804) CONTENTS Pre-Installation Requirements..........................................................................................................................................2 Electrical Requirements..................................................................................................................................................3 Exhaust Syste

3 Bolt the dryer to the stand using the four 5/16”-18 bolts provided. Tools for installation: . 3/8” and 9/16” wrench . Hoist Mounting the Dryer and Hopper on a Mobile Floor Stand CAUTION: To prevent accident and injury, lift the empty hopper and the dryer onto the mobile floor stand using a hoist and the lifting lugs provided. Tools for installation: . 5/32” Allen wrench . 3/8” and 9/16” wrench . Phillips screwdriver . Flathead screwdriver . Hoist and strap 1 Lift the hopper onto the mobile flo

5 Dryer Operation .................................................................................................................................. 6 Emergency Stop ................................................................................................................................. 6 Safety Precautions ............................................................................................................................. 7 Chapter 2 Safety Alert Decals .........................

To configure your 208V or 240V tumbler for 208V operation, you must remove the 240V configuration jumper located in the contactor box and replace it with the 208V jumper supplied with the information packet. This must be done prior to supplying power to machine. Failure to install proper configuration jumper may result in damage to sensitive electronic controls and may void warranty. To configure your 380V or 415V tumbler for 415V operation, you must remove the 380V configuration jumper located