valutazioni - 4, GPA: 4.3
(
)
)
|
Facilità d'uso
REV:0 Scale: Engineering Dept: Artwork By: Date: 2006-9-21 Checked By: Date: Approved By: Date: SPECIFICATIONS SPECIFICATIONS Receiving System : DK , I , M Colour System : PAL / NTSC Picture Tube : 54cm (21") diagonal Ext. Antenna : 75 Ohm Coaxial Cable Ext. In/Out : Audio/video -in/out Speaker : 8 Ohm(8W) x2 Audio Output(MAX) : 1KHZ 0.5Vrms, 6Wx2 10% THD Audio Output Power : 1KHZ 0.5Vrms, 6Wx2 Power Consumption : AC 220V 50/60Hz, 80W MAX Standby Power Consumption : AC 220V 50/60Hz, 5 MAX Dimension : 600(W) x 475(D) x 452(H)mm Net Weight : 24kg REMOTE CONTROL Transmitting System : Infrared Power Supply : DC 3V (1.5 x 2) Dimension : 28(W) x 155(L) x 45(D)mm Net Weight : 83 g Design and specifications are subject to change without prior notice. CONTENTS CONTENTS INTRODUCTION............................................................................................................................... 2 WARNINGS and CAUTIONS ............................................................................................................ 3 - 4 CONTROL LOCATION ....................................................................................................................... 5 INPUT and OUTPUT ......................................................................................................................... 6 OPERATION INSTRUCTIONS ........................................................................................................... 7 - 9 LOCATION OF CONTROL(REMOTE CONTROL UNIT) .................................................................... 10-11 LOCATION OF CONTROL(REMOTE CONTROL UNIT) (TELETEXT OPTION) ................................... 12-13 BATTERY INSTALLATION............................................. .................................................................... 14 SERVICE TIPS .................................................................................................................................. 15 -1 INTRODUCTION Thank you very much for your purchase of this product-the most natural Colour Television Receiver. To enjoy your set to the full from the very beginning, read this manual carefully and keep it handy for ready reference. INSTALLATION Locate the receiver in the room where direct light does not strike the screen. Total darkness or a reflection on the picture screen can cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing. Allow enough space between the receiver and the wall to permit ventilation. Avoid excessively warm locations to prevent possible damage to the cabinet or premature component failure. This TV receiver can be connected to AC 220 Volts,50/60 Hz .Never connect to DC supply or any other power supply. Do not install the receiver in a location near heat sources such as radiator, air ducts, direct sunlight, or in a place somewhere like close compartment and close area. Do not cover the ventilation openings when using the set. CAUTION Never tamper with any components inside your set, or any other adjustment controls not mentioned in this manual. All television receivers are high voltage instruments. The PICTURE TUBE of the TV set is in a almost vacuum condition. If broken, glass fragments will be violently expelled. Scratching, chipping or undue pressure is dangerous and should be avoided. When you clean up dust or stick of a water drop on the PICTURE TUBE FACE or CABINET, the power cord should be pulled out from the plug receptacle, then wipe the receiver with dried soft cloth. During thunder and lighting, unplug the power cord and antenna cord to prevent your TV set from damage. All "inside work" on your receiver should be performed only by the TV service personnel. -2 -3- -4- CONTROL LOCATION 10. AC Power Cord 11. Antenna Input Socket (75 Ohm) 12. S-Video Terminals 13. Y Cb Cr Terminals 14. AV in1 Terminals 15. AV out Terminals -5- 1. Main Switch 2. Power Indicator 3. Remote Sensor 4. Speakers 5. Side AV In (Option) 6. Menu Button 7. Program Down /Up Button 8. Volume Down/Up Button 9. AV/TV 5 4 7 7 8 8 6 9 3 2 1 4 15 10 14 13 12 11 -6- INPUT AND OUTPUT TERMINALS S-VIDEO VIDEO AV OUT VIDEO Y Cb LEFT RIGHT LEFT RIGHT LEFT RIGHT Cr Y Cb Cr IN OPERATION INSTRUCTIONS WARNING: The main power switch (No.1 of the control location page ) is the manually operated mechanical switch . The remote control can not cut off power supply to the TV set. For safety purpose, push main switch to the OFF position and make sure the power indicator go out when not use for long time. Push the power "ON/OFF"switch to the ON position, and then power indicator will light up, the picture(or blue screen) will appear within a few seconds. MENU BUTTON 1.Press this button to select PICTURE..SOUND..TIME..TUNE.. SETUP..EXCHANGE menu cyclically. PICTURE SOUND TIME TUNE EXCHANGE SETUP 2.After entering into each menu, you can select submenu which you will adjust with PROG.+/- Buttons or (GREEN) /BLUE buttons. Then you can adjust it with VOL.+/- Buttons or the +...