for #3 rebar and drilled .218 for ..4-20 self tapping grounding screw and galvanized or painted for protection. 1 - Pole and foundation design based on the following criteria: a) Uniform building code exposure B or C and 1.5 stability factor. b) Vertical soil pressure of 2000 pounds per square foot. BubbleLevelGround PoleMust BeVertical InAll DirectionsWithin .19 InchesAt Top (0.3.) c) Lateral soil pressure of 400 pounds per square foot. d) Concrete compressive strength of 2500 pounds per square

A World of Solutions. International Telephone: +1-708-873-2307 Fax: +1- 708-349-5444 Internet: DO NOT DISCARD CONTENTS The product in this packaging was placed in the market after August 13, 2005. Its components must not be discarded with normal municipal or household waste. Contact your local waste disposal agency for recovery, recycling, or disposal instructions. HARDWARE SORTER HARDWARE SORTER DATE DESCRIPTION REV. 1/06 ECN9007200 Rev A 8/06 ECN9007484 Rev B VSAT ANTENNA/MOUNT/LNB LIMITED TWE

DIA. NOTE: 48" may be increased, concrete and length of rebar will increase accordingly. 2 ..." O. D. DEEP FROST LINE FOUNDATIONS ............ (SEE NOTE) 1-1.5" APPROX. 2" .... (4) #3 x 24" MIN. AT 90° APART (SEE NOTE) PIER FOUNDATIONS DEEP FROST LINE FOUNDATIONS 7 15 8 5 6 9 11 13 12 4 6 14 CLAMP SURFACE 96 7 10 Junction Block (9) FIG. 4.1 - ANTENNA, ANTENNA FEED (LNB) & FEED SUPPORT LEGS ANT WIND VEL. DIM “d” CONC VOL. DIM “d” CONC VOL. GROUND POLE 90cm 80 MPH 90 MPH 100 MPH 110 MPH 125 MPH 9”

Printed in U.S.A. . 10500 West 153rd Street . 1315 Industrial Park Drive . Fax: +1-919-989-2200 . ECN 9006666 .. . Orland Park, IL U.S.A. 60462 Smithfield, NC 27577 USA Internet: 5/04 8000284-01 VSAT ANTENNA/LIMITED TWELVE (12) MONTH WARRANTY DATE DESCRIPTION REV. 2/26/90 Changed Pages 4, 6, 7, 8, 9 and 10. ECN 9001516 A 4/20/90 Changed Pages 3, 4, 5, 6, 7, 8, 9 & 10. ECN 9001550 B 9/10/90 Changed Cover, Pages 1, 6, 7, 12 & 13. ECN 9001616 C 11/19/90 Changed Cover, Pages 1, 3, 4, 5, 6, 7, 8, 0,

ANTENNA MOUNT ASSEMBLY BOTTOM FEED LEG HOLE 2 3 1 FIG. 2.0 - ASSEMBLING REFLECTOR TO AZ/EL CAP MOUNT FEED AND FEED LEGS INSTALLATION Assemble feed assembly and feed legs to antenna as shown in Fig. 2.2. Insert bottom feed leg (4) into hole in bottom edge of antenna (5). NOTE: Bottom feed leg is the one with a slight bend on one end of leg, lance on opposite end, and is shorter than the two side legs (6). Install side legs (6) to antenna. From back side of antenna, secure with M6 x 30mm ( ...” x