Log:
valutazioni - 0, GPA: 0 ( )

Istruzioni per l'uso HP, Modello HP 4400 Dual Controller Enterprise Virtual Array w/Embedded Switch

Produttore : HP
File Size : 261.95 kb
File Nome :
Lingua di insegnamento: en
Vai a scaricare



da questo dispositivo ha anche altre istruzioni :

Facilità d'uso






7.
Pull up on the riser assembly to unseat it from its mating connector
5.
Reinstall the enclosure into the rack (observing the two-man lift
on the midplane board (Figure 4).
requirements), and reattach the enclosure front bezel.
6.
Reattach all cables (Fibre Channel and/or SAS, Ethernet, power)
cables to the enclosure components.
7.
Power up attached disk enclosures by pressing the power button
on the rear power UID bezel of each disk enclosure.
8.
Power up the controller enclosure by pressing the power button on
the rear power UID bezel of the controller enclosure.
Verifying proper operation
NOTE:
Wait approximately five minutes for the system to check the
status of components after the enclosure is powered on.
Figure 4 Removing the riser assembly
.
After replacing the riser assembly, verify that the green LEDs are lit on
Installing a riser assembly
the management module and the power UID.
1.
Align the connector on the bottom of the replacement riser assembly
with its mating connector on the midplane board and press down
to seat the connectors (Figure 5). The tabs on the metal riser cover
insert into the slots in the enclosure.
Figure 5 Attaching the riser assembly
.
2.
Attach the cable connector from the power UID assembly into the
connector on the riser assembly.
3.
Reattach the top access cover by sliding the cover onto the enclosure
and tightening the cover thumbscrew.
NOTE:
The top access cover helps properly align the riser
assembly by pressing down on the raised portion of
the riser assembly bracket. Do not install the
management module until the top access cover has
been attached to the enclosure, or you may have
alignment difficulties.
4.
Insert the management module into the enclosure, and push it in
until it clicks to indicate it is fully seated.
Page 3

...

Questo manuale è adatto anche per i modelli :
dati dispositivi di elaborazione - HP 4400 Dual Controller Enterprise Virtual Array (261.95 kb)
dati dispositivi di elaborazione - HP EVA P6350 450GB 10K SAS Field Starter Kit (261.95 kb)
dati dispositivi di elaborazione - HP EVA P6350 450GB 10K SAS FIO Starter Kit (261.95 kb)
dati dispositivi di elaborazione - HP EVA P6350 900GB 10K SAS Field Starter Kit (261.95 kb)

Scrivi la tua opinione del dispositivo



Il messaggio
Il tuo nome :
Inserire le due cifre :
capcha





categorie