valutazioni - 0, GPA: 0
(
)
)
|
da questo dispositivo ha anche altre istruzioni :
Facilità d'uso
e. Connect the SCSI and drive power cables to the drive.
f. Mount the drive into the enclosure using 4 T-10 screws; 2 on each side.
g. Replace each drive enclosure’s top cable access plate by inserting and tightening the T-10 screw
on each side of the plate.
5. Mount the enclosures into the chassis.
Slide the drive enclosures into the enclosure stack such that the slots on the bottom of each side of
the enclosure slide over the tabs sticking out from each side of the stack. Two tabs near the front of
the stack will support the rear portion of the enclosure. (See the next Figure.)
After inserting the drive enclosure, try moving the drive up and down a little. If the tabs are engag-
ing the slots correctly, you should not be able to move the drive. Refer to Figure 8.
Figure 8: Front slot on drive enclosure and stack tabs
a. Insert the T-20 screws (on the left side of the drive enclosure) and tighten, to secure the enclo-
sure.
6. Attach the following cables to the interposer PCA, as illustrated in Figure 9 and 10.
a. drive interface cables
b. SCSI cables
c. fan power cables
d. drive power cables.
11
... Questo manuale è adatto anche per i modelli :
dati dispositivi di elaborazione - HP Surestore 160ex Optical Jukebox (76.22 kb)