valutazioni - 4, GPA: 4.5
(
)
)
|
Facilità d'uso
• When using for the first time, soft scents or smokes may occur. This situation is not of big concern and stops after a little while. Take care of full ventilation capabilities. • Push downwards the sealing of the water filling hole (12). • Fill in the pipe water through the water filling hole (12) till it reaches the mark MAX (9) of the water holder (6). If water hardness exceeds 17 dH, use exclusively distilled water. Ask your supplier about the water hardness. Never use chemically unhardened water! • Push the sealing of the water filling hole upwards (12) . • Plug the cord (5) in the appropriate mains and place the temperature control rotating knob (7) to the MAX. The red (4) and the green (3) control lamps are lighted up. When the red (4) control light goes off, push the steam release button (1) and start ironing over an old rag. If all the steam vanishes, the device is ready to use. OPERATION Dry ironing • Fill up the water holder (6), as described above. • For dry ironing, place the steam selector rotating knob 0/ / / (13) in the 0 Position. • Connect the mains plug (5) to an appropriate mains socket and select the desired temperature on the temperature control (7). The red (4) and green (3) control lamps are lighted up. When the selected temperature is reached, the red control light (4) goes off. If the iron cools too much down, the red control light (4) lights up again, showing that the iron is heated again. Adjustments: min = Off (Aus) • = Acrylics, Silk •• = Synthetic Silk, Wool ••• = Cotton, Clothes-line max = Maximal temperature • Before selecting the working temperature, carefully read the iron instructions or the fabric care instructions of the clothes. 5 6 DB108 7/13/06 12:06 PM Page 5 GB GBGB • Warning! If no fabric care instructions are attached to clothes, temperature. Working on lower temperatures, less steam is ejected. Attention: Synthetics can melt down. • Iron only over the piece of cloth. • To switch off the device turn the temperature control (7) clockwise into MIN position, place the iron in a vertically position and unplug it from the mains. • STEAM IRONING: This is possible only in the ••• and MAX position. • Fill up the water holder (6), as described above. To operate properly, the water holder must be filled up at least at 1/4 of its capacity. • Select the desired steam amount using the steam selector rotating knob 0/ / / (13). In the position the largest steam amount is delivered. Always hold the iron horizontally. • In order to get an extra steam push, press the steam release button (1) . • Spray feature: Press the spray button (14) , in order to wet a ironing surface. Water will spray out of the spray nozzles (11). • Vertical steaming: Hold the device vertically at about 15 – 30 cm in front of the clothes and press the steam release button (1), in order to get rid of the folds on the hanging clothes, curtains and fabrics. • Warning! The steam temperature is extremely high. Do not use the steam operation over clothes placed on humans or animals. • To switch off the device, turn the temperature control button (7) into the MIN position and unplug it from the mains. • Push the sealing of the water filling hole downwards (12) . • Turn the device head down, and carefully shake out the remaining water from the water holder (6). Carefully shake the device. • Press the spray release button (1) and the spray button (14), in order to get rid of the water still remaining into the device. Auto shut off feature • If the device stays untouched 30 seconds in horizontal position or 8 minutes in vertical position, it turns off by itself. The red control light (3) blinks. As soon as you get hold of the device again, it turns on by itself. GB GBGB CLEANING AND MAINTENANCE • Unconditionally read the safety instructions. • Take care to unplug the device from the mains and allow minutes. • Clean the device on the outer surface with a soft, wet rag, • Never use hard detergents or devices. • Wipe the iron base with a wet rag. Self clean feature • In order to get rid of lime-stone, fulfil the self cleaning feature monthly. • Fill the water holder of the iron at its middle level, as already described. • Place the device vertically on a flat surface and plug it to the mains. • Turn the temperature control (7) to the MAX. As soon as the red control light goes off for the second time, turn the temperature control (7) to the MIN and unplug the device from the mains. • Hold the device horizontally over a wash-basin and turn the steam selector to the 0 position. • Push and hold down the self clean button SelfClean (8) until no more water flows out of the water holder. Slowly swing the device. TECHNICAL FEATURES Mains power : 230V~ 50Hz Power consumption: 1800 Watt GUARANTEE AND CUSTOMER SERVICE Before delivery our devices are subjected to rigorous quality control. If, despite all care, damage has occurred during production or transportation, please return the device to your dealer. In addition to statutory...