valutazioni - 4, GPA: 4
(
)
)
|
Facilità d'uso
Do not leave iron unattended while connected or on an ironing board. 9. Burns can occur from touching hot metal parts, hot water,or steam. Use caution when you turn a steam iron upside down - there may be hot water in the reservoir. SPECIAL INSTRUCTIONS 1. To avoid a circuit overload, do not operate another high wattage appliance on the same circuit. 2. If an extension cord is absolutely necessary, a 10 ampere cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over. SAVE THESE INSTRUCTIONS ©2004 Matsushita Electric industrial Co., LTD. All rights reserved. -2- NOTE: 3 position steam button. С*-*-*- V Dry Low steam High steam Electronic 3-Way AUTO SHUT-OFF FUNCTION (Button UP : for High steam, MED: for Low steam Temperature Zone Steam Button Position a jaor_& Now steam ironing can begin 6. Whenever the iron is set vertically the steaming action will stop. NOTE: Do not use the steam button unless the iron is sufficiently hot enough to produce steam, otherwise water will leak out through the vents instead. HOW TO USE AS A DRY IRON 1. Press the steam button down to the dry position. 2. Place the iron vertically, set the selector dial to OFF. 3. Plug in the iron. 4. Set the temperature selector dial to the desired position. (Refer to the Fabric Ironing Chart in this manual on page 10) 5. Preheat the iron until the indicator light goes out, usually about 1-2 minutes. HOW TO USE THE SPRAY FEATURE Before using the spray feature, check the garment label for ironing instructions because some fabrics may spot or stain with moisture. The spray feature is particularly helpful for removing stubborn wrinkles and where extra dampening is needed. The spray may be used with steam or dry ironing. 1. Simply pump the spray button when spray is desired. If the spray doesn't work immediately just keep pumping till it does. 2. To get a finer spray, pump the button vigorously. To get a more powerful spray, pump the button more slowly. For best results, use a quick, full stroke. (This picture is NI-H20NR) 1. When the iron is left unmoved with its soleplate facing down or on its side for approx. 1 minute, the iron will automatically shut off power to the heater by itself. 2. When the iron is left unmoved on its heel rest for approx. 10 minutes, the iron will automatically shut off power to the heater by itself. 3. To turn the iron back on to resume ironing, simply move the iron in any way. Reheat the iron until the indicator light goes out, if you have left the iron in the auto shut NOTE: 1. The Auto shut off system works regardless of position of the temperature selector dial, even at "OFF" position. 2. When you finish ironing, always unplug the iron. X. Licensed under U.S.patent No. 4,686,352 and foreign counterparts. HOW TO USE JET OF STEAM FEATURE (NI-H20NR/H24NR Only) The jet of steam feature provides extra steam which goes deep ...
Questo manuale è adatto anche per i modelli :Ferri - NI-H24NR (1.52 mb)
Ferri - NI-H20NR (1.52 mb)
Ferri - NI-H14NS (1.52 mb)
Ferri - NI-H10NS (1.52 mb)