valutazioni - 1, GPA: 5
(
)
)
|
Facilità d'uso
Repeat this operation until the circumference of the roller reaches 770 mm. 4. Spread the flannel evenly over the padded roller and tighten with the ironing plate under pressure until it is fully wound. Raise the temperature to approx. 130°C and let the roller rotate for a few minutes until the flannel cover is settled. 5. Place the narrowest end of the cover sheet approx. 10 cm under the edge of the flannel, making sure it is perfectly smooth and parallel. Put the ironing plate under pressure and wind the sheet round. Let the roller rotate for a few minutes. When the cover sheet is settled, secure the ends. Every maintenance operation must be carried out by professionally qualified personnel. TROUBLESHOOTING TROUBLE POSSIBLE CAUSE REMEDY Upon switching on the ironer does not work. Mains power failure. Magnetothermal switc h intervention. Card protection fuse (F4) blown. Check if supply terminals are live. Check dispersion toward earth. Replace fuse and check for cause. The roller does not turn and the ironing plate does not drop. Motor fuse (F3) blown. Motor thermal feeler activated. Emergency devices activated (display shows “Err”.) Replace fuse and check for cause. Wait some minutes for the reestablishment of feeler contact. Disactivate the emergency device and press the pedal. After adjusting the temperature by means of the thermostat, the ironing plate does not heat. Safety thermostat activated. Thermostat probe disconnected: display shows “Er1” for the right, “Er3” for the left. Thermostat probe in short circuit: display shows “Er2” for the right, “Er4” for the left. Measured temperature difference between right and left probes higher than 40°C. Reset the safety thermostat using the relative push button. Check probes connection. Use properly the whole ironing surface. N.B.: All checks and any technical work must be carried out by fully competent, qualified personnel. FR TRANSPORT - HANDLING - DEBALLAGE Le transport de la calandre doit etre effectue comme illustre sur les dessins a l’exterieur de l’emballage. Les elements de l’emballage (sachets en plastique, polystyrene expanse, clous, vis, bandes metalliques ou en plastique, etc.) ne doivent pas etre laisses a la portee des enfants ou abandonnes dans l’environnement, pouvant representer une source de danger et de pollution. Ces materiaux doivent etre jetes dans les endroits prevus a cet effet. INSTALLATION Deballer la calandre et verifier qu’elle n’ait subi aucun degat. Ouvrir les portes au moyen de la cle speciale et enlever les vis de fixation au bati. Positionner la calandre dans un local adequatement eclaire, avec une temperature ambiante comprise entre +10°C et +40°C. Poser la machine sur une surface plane (portee minimum 500 kg/m.), de maniere stable et horizontale, en utilisant les petits pieds reglables situes a la base des cotes. Pour un correcte usage et fonctionnement, aussi que pour une facile entretien, laisser un espace libre autour de la calandre comme par figure 01. BRANCHEMENT ELECTRIQUE Le branchement doit etre effectue par un personnel qualifie. Controler que la tension d’alimentation corresponde bien a la tension reportee sur la plaquette signaletique de la calandre. La plaquette est situee sur le cote arriere droit de la machine. Afin de garantir un branchement electrique en toute securite, utiliser un cord...
Questo manuale è adatto anche per i modelli :Ferri - RI1400/25 AV (654.41 kb)
Ferri - RI1400/25 F (654.41 kb)