valutazioni - 0, GPA: 0
(
)
)
|
Facilità d'uso
The iron should not be used if it has been dropped, if there are visible signs of damage or if it is leaking water. In these cases, it must be checked by an Authorised Technical Service Centre before it can be used again. Remove the plug from the socket before filling the appliance with water or before pouring out the remaining water after use. Never immerse the iron in water or any other fluid. The appliance must never be placed under the tap to fill the water tank. Do not leave the appliance exposed to the elements (rain, sun, frost, etc.) The electrical plug must not be removed from the socket by pulling the cable. Unplug the appliance from the mains supply after each use, or if a fault is found. With the aim of avoiding dangerous situations, any work or repair that the appliance may need, e.g. replacing a faulty mains cable, must only be carried out by qualified personnel from an Authorised Technical Service Centre. Unplug the iron from the mains supply when you have to leave the iron unattended. Important warnings Do not allow the power cable to come into contact with the soleplate when it is hot. Store the iron in upright position. Do not use descaling agents (unless recommended by Siemens) as these can damage the appliance. Troubleshooting guide for minor issues Problem Probable cause Solution The iron does not heat up. 1. Temperature control dial in very low position. 2. No mains supply. 1. Turn to a higher position. 2. Check with another appliance or plug the iron into a different socket. The light does not come on. 1. The iron is cooling down. 2. The iron does not heat up. 1. Wait: heating cycle. 2. See previous section. Garments tend to stick. 1. Temperature too high. 1. Turn the temperature control dial down and wait until the iron has cooled down. Water comes out together with steam. 1. Temperature regulator very low. 2. Steam regulator set high with low temperature. 1. Turn the temperature control dial regu lator to a higher position and wait until the operating indicator switches off. 2. Turn the steam regulator to a lower position. Steam does not come out. 1. No water in the tank. 2. Temperature too low; below “••” and the pump does not work. 1. Fill the tank. 2. Select a higher temperature, between “••” and “max” if compatible with the fabric. Spray does not work. 1. No water in the tank. 2. Obstructed mechanism. 1. Fill the water tank. 2. Contact the Technical Service. fr Nous vous remercions d’avoir achete le fer a vapeur TS11 de Siemens. Cet appareil est exclusivement concu pour une utilisation domestique et ne doit en aucun cas etre utilise a des fins industrielles. Lisez attentivement le mode d’emploi de l’appareil et conservez-le pour une consultation ulterieure. Avertissements de securite Risque de decharge electrique ou d’incendie! Cet appareil ne doit etre branche et utilise qu’avec un reseau electrique, conformement aux informations indiquees sur sa plaque signaletique. Ne branchez jamais l’appareil a l’installation ele...
Questo manuale è adatto anche per i modelli :Ferri - TS11120/02 (3.11 mb)
Ferri - TS11333/01 (3.11 mb)
Ferri - TS11EXTREM/01 (3.11 mb)
Ferri - TS11XTRM/01 (3.11 mb)