valutazioni - 1, GPA: 5
(
)
)
|
Facilità d'uso
This cleans the steam valve inside the iron. Protective Soleplate Shield (not available on all models) There is no need to wait for the iron to cool before storing. Make sure the iron has been turned off and unplugged. Empty all water from iron. Place the soleplate cover on the iron immediately after ironing. CAUTION: The soleplate may be hot, so care must be used in placing the cover on the soleplate. Retractable Cord (not available on all models) 1. Press and hold the Cord Release Button while pulling cord to desired length. Do not unwind cord beyond indicator on cord. Cord Release Button 7 840084900 Ev01 5/24/01 1:44 PM Page 8 Retractable Cord (continued) Wind clockwise Retractable Cord Handle 1 2 2. To store cord, place the iron, soleplate down, on ironing board. Unlatch Retractable Cord Handle and wind clockwise. IMPORTANT! Do not press Cord Release Button while winding cord. Only wind clockwise or the cord may jam. See illustration. 3. If cord jams while winding, push the Cord Release Button to unwind slightly until cord is free. Then slowly start to wind clockwise again. If Retractable Cord Handle comes off, it is designed to snap back into place. 1. Place pins of handle into slots in reel. See illustration. 2. Lift handle up until it snaps in place. Storing Your Iron 1. When finished ironing, turn the Temperature Control Dial to 0 (OFF) and unplug iron. Set iron on its heel and let cool. NOTE: If you have the Protective Soleplate Shield, you can store the hot iron immediately. 2. Empty all water in iron. If the water is not emptied, it may interact with the metal of the iron and cause the water to discolor. This will result in steam and water droplets discoloring clothing. Carefully hold iron over sink with water tank opening aimed down. Let all water drain out. 3. To clean the soleplate, wipe with a wet cloth and dish detergent. Wipe clean with a damp cloth. Do not use abrasive cleaners. CAUTION: Be sure iron is cool prior to cleaning. 4. To maintain good steam production, clean the iron periodically using the self-clean setting described in the “Self-Clean System” section. 8 840084900 Ev01 5/24/01 1:44 PM Page 9 5. Wrap cord loosely around cord wrap and set on heel. If you have the retractable cord feature, use the reel to wind and store the cord as described in Troubleshooting PROBLEM Iron won’t heat. Water is leaking out of the iron. Iron won’t steam. Iron leaves spots on clothing. Cord is kinked or twisted. THINGS TO CHECK the “Retractable Cord” section. Never store iron sitting flat on the soleplate. This will damage the inside of the soleplate. Always store iron on its heel in upright position. • Is the iron plugged in and the Auto Shutoff Reset Button/Light on? If not, press the Auto Shutoff Reset Button/Light to turn the iron back on. • If the iron is plugged in and the light does not come on, check the outlet by plugging in a lamp. • Is the Temperature/Steam Dial turned to a fabric setting? • If you over filled the water tank, empty some water. • Is the Temperature/Steam Dial in the steam range and did the iron have enough time to preheat? • If ironing for more than one hour the auto shutoff may have turned the iron off. Press the Auto Shutoff Reset Button/Light to turn the iron back on. • Is there water in the water tank? • Is the Temperature/Steam Dial set in the steam range and did the iron have enough time to preheat? • Has the iron been cleaned with the self-clean feature? The steam vents may be blocked. • ALWAYS empty the water tank of the iron after using. Water left in the tank may discolor. • Clean the steam vents as instructed in the “Self-Clean System” section. • Unplug iron and let cool. Hold iron cord in the middle of entire length. Let plug and iron dangle freely until cord uncoils. This will extend the life of your iron cord. 9 840084900 Ev01 5/24/01 1:44 PM Page 10 Customer Assistance If you have a claim under this warranty, please call our Customer Assistance Number. For faster service please have model, series, and type numbers ready for operator to assist you. These numbers can be found on the heel rest of your iron. MODEL: ________________ TYPE: _________________ SERIES: __________________ Customer Assistance Number: 1-877-556-0973 Keep this number for future reference! E-mail inquiries: Two-Year Limited Warranty What does your warranty cover? • Any defect in material or workmanship. For how long after the original purchase? • Two years. What will we do? • Provide you with a new one. How do you make a warranty claim? • Save your receipt. • Properly pack your unit. We recommend using the original carton and packing materials. • Return the product to your nearest WAL-MART store or call Customer Assistance at 1-877-556-0973. What does your warranty not cover? • Glass parts, glass containers, cutter/strainer, blades and/or agitators. • Commercial use or any other use not found in printed directions. • Damage from misuse, abuse, or neglect. • Products purcha...
Questo manuale è adatto anche per i modelli :Ferri - 106636 (535.46 kb)