valutazioni - , GPA: ( )

Istruzioni per l'uso Frigidaire, Modello EM 4.58 D

Produttore : Frigidaire
File Size : 1.07 mb
File Nome : 95322a4f-2519-9a24-41cf-421584aac5d5.pdf

Lingua di insegnamento:

Il documento viene caricato, si prega di attendere

Scarica la tua primo

Il documento viene caricato, si prega di attendere

Scarica la tua primo

8 a and 8 b. The screw caps which are used to hold the work surface have to be hand tightened only. the fat in the pan, because the cooker plates in themselves are manufactured absolutely level. ked with lines which have to meet up if the parts have been joined together correctly. The earth wires of the cooker plates have to be connected up with the earth wires of the switch strip; to be tightened with the enclosed special screws. Final Adjustment of the Cooker Plates If not already the case, the cooker plates can be made level by finally adjusting them with the adjusting screws (1-2-3) which can be reached from underneath (fig. 9). Connection of two built-in hob unites Fig. 10 SI m 1 Rail to give protection from the top 2 Rail to support the joint from below 3 Screw "M3x 8“ 4 off 4 Seal The built-in hob units should be placed in the aperture side by side. The rail 1 and the seal 4 should be placed between the hobs from the top as indicated in fig. 10. Rail 2 should then be screwed against rail 1 by using screws 3 (4 off). After that the built-in hob units should be tightened as described in the installation instructions. The Connection IMPORTANT: SEE FOOTNOTE ON PAGE 3 AEG electric built-in appliances conform to safety regulations laid out by VDE (“Association of German Engineers“)/CEE. According to these heat emission can be as high as 60° plus room temperature. Should any damages occur, please consult the dealer from whom you have obtained the appliance, or your AEG Service Agent. 106 Fig. 11 A After screws 1, 2 and 3 have ^ been untightened, the tope of the installation case can be lifted up. B. FOR THE HOUSEWIFE Description of the Cooker Plates and the ‘‘Seven Position Switch“ According to the type, your built-in hob unit can be fitted with the following cooker plates: 18 cm (7“) Regia automatic plate (large red dot) = 2100W 14.5 cm (5%“) Regia automatic plate (large red dot) = 1500 W 18 cm Quick Action cooker plate with kmall red dot = 2100W 14.5 cm Quick Action cooker plate with small red dot = 1500W 18 cm standard cooker plate without special marking = 1500 W 14.5 cm standard cooker pla- te without special marking = 1000W Ther cooker plates are of a heat resisting special cast construction, and are built-in firmly into the hob. The cooker plates are set into a stainless steel hob so that boiled over food cannot get under the cooker plates or into the cupboard. The heat output of the individual cooker plates can be regulated over a wide range with the approved seven position switch. The knobs of the appliance to be fitted underneath the hob unit as well as the knobs of the control panel for the hob unit can be switched into 6 different positions besides the "off-posi- tion“ 0. On the dial plates you find the numbers 0, III, II and I and between the numbers one dot. The dots between the numbers indicate three addational intermediate positions. You have to select these Intermediate positions when...